Blind Control

[Graham]

I'm trying to figure out how to setup blind control in Cortex before my modules arrive. The plan is to use DRH's to control the blind motors (which have 4 cables - earth, neutral and 2 lives [brown & black]). I've added a DRH to Cortex along with a Motor Control, connected a QBI to Open/Close the Motor Control, but I don't seem to be able to make it work.

Does the network side of Cortex have to be running for this simulation to work?

Thanks in advance
Graham

[Karam]

Yes the network needs to be running. If you visit Tools | Network Supervisor | Service tools and click on Disable all network nodes you may then be able to run your test network and see what happens using simulated key presses.