My system has been installed for just over 6 months. Three weeks ago, the fault log started reporting frequent HWV and Heating Actuator communications faults. My installer changed both BDR faceplates.
For two weeks, with the new BDRs, the system has been fine. Last week, however, the controller re-set itself whilst connected to its powered wall mount: some zones took over 90 minutes to re-synchronise. This evening, the actuator ( both hot water and heating) communications faults have returned. The BDRs have 12 inches separation and are mounted above and about 4 ft displaced from the controller.
Sadly, I am beginning to lose some faith in the technical reliability of the Evohome system. I now wait to hear what my specialist installer proposes to do to give me confidence in this expensive control system. At the moment, I do not think that I could leave my home empty without worrying that either my home was unprotected, or I would come to an enormous heating bill.
For two weeks, with the new BDRs, the system has been fine. Last week, however, the controller re-set itself whilst connected to its powered wall mount: some zones took over 90 minutes to re-synchronise. This evening, the actuator ( both hot water and heating) communications faults have returned. The BDRs have 12 inches separation and are mounted above and about 4 ft displaced from the controller.
Sadly, I am beginning to lose some faith in the technical reliability of the Evohome system. I now wait to hear what my specialist installer proposes to do to give me confidence in this expensive control system. At the moment, I do not think that I could leave my home empty without worrying that either my home was unprotected, or I would come to an enormous heating bill.
Comment