If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Let's say that the temperature program has 20° C as setpoint for a zone with an HCW82 installed, and this one is set to +3° C. What exactly happens? What setpoint is shown on the controller? 23? Showing a local override?
Thanks
Indeed, the HCW82 will 'offset' the setpoint temperature. So if the zone it is located in is 'scheduled' to 20 degrees and the HCW82 is set to +3 it will be +3 degrees on the evohome setpoint (i.e. 23 degrees). When the evohome Controller changes scheduled setpoint to say 16 degrees and the HCW82 was left at +3 it would actually control the room temperature at 19 degrees.
Comment