Hi,
I have electric UFH and am unsure how to connect the temp sensor to a QAI input. Do I just connect it to 0v and input 1 or do I need to connect it to a voltage and use an pull down resistor.
The details on the temp sensor are a little sketchy. It's an NTC type and gives a reading of about 10k @ 25c. I have again contacted the company that makes it to get further details but I may have to try to figure this one out on my own.
If I can get some sane readings from the QAI I will be able to figure out the rest as I can use the manufacturers thermostat to set the temp and to read the resistance at various temps. Just need help on how I should properly connect to the QAI input (I know that unused inputs should be connected to 0v).
Thanks for the assist.
Chris.
I have electric UFH and am unsure how to connect the temp sensor to a QAI input. Do I just connect it to 0v and input 1 or do I need to connect it to a voltage and use an pull down resistor.
The details on the temp sensor are a little sketchy. It's an NTC type and gives a reading of about 10k @ 25c. I have again contacted the company that makes it to get further details but I may have to try to figure this one out on my own.
If I can get some sane readings from the QAI I will be able to figure out the rest as I can use the manufacturers thermostat to set the temp and to read the resistance at various temps. Just need help on how I should properly connect to the QAI input (I know that unused inputs should be connected to 0v).
Thanks for the assist.
Chris.
Comment