8th January 2017, 03:56 PM
Automated Home Jr Member
Low level wash lighting for Bathroom
Has anybody installed low level wash lighting in a bathroom? I'm interested in what products you used. I'm fed up with being rudely awaken due to brightness if I need to use the bathroom in the middle of the night. So I saw some eyelid LEDs in a posh bathroom shop but they were £200 for the lights and £90 for the PIR because "it was special" and that's about all I could get from them.
I've been trawling the internet most of morning for something neat and this is as good as I've got so far...
Sensio Nimbus 6 Pack - £33
Sensio PIR Sensor - £28
These together seem to make up a solution but, the one's I saw had an eyelid which means all the light went down to the floor. I found one that looked the part - (ILS EYELID1W) but the LEDs were £94 each! Also another on mr-resistor that I like and at a more 'reasonable' £39 each. Both had to have driver and PIR extra.
If anyone has come up with a good solution with nice looking lights I'd really appreciate some idea of what you ended up with.
Last edited by redw0001; 8th January 2017 at 04:43 PM.
8th January 2017, 05:31 PM
Automated Home Legend
I have one of these on the wall above the loo, about a foot above head height. It's enough light for an accurately aimed pee, but not enough to wake me up fully.
No automation of course - you have to press it! I tried sensor light, but the batteries don't seem to last. By Dot-It seems to go for about two years on a set of batteries.