Hi All,
I have been using Honeywell Evohome system for the last two years. It has been working like a charm including the Hot water kit until this year, where I decided to reset the system to factory default settings. I was able to bind and setup everything but I found it tricky to perform the following:
1. When resetting the HR92's (Menu #12 option 1) in some case I noticed that the zone still remains on the HR92. Shouldn't that disappear until i bind it again with the controller?
2. when I was able to bind everything in the past (through guided configuration) - 4 heating zones (1 HR92 each) and the Hot water, whenever I was starting the hot water wireless relay (via the controller) the Heating wireless relay was also switched on (both of them instantly) and when I was switching it on the Heating BRD91 was going off but the HW was still on.
Note: the two BDR91 are at least 7 meters away from each other.
Can anyone provide some feedback on what the issue might be in those cases
I have been using Honeywell Evohome system for the last two years. It has been working like a charm including the Hot water kit until this year, where I decided to reset the system to factory default settings. I was able to bind and setup everything but I found it tricky to perform the following:
1. When resetting the HR92's (Menu #12 option 1) in some case I noticed that the zone still remains on the HR92. Shouldn't that disappear until i bind it again with the controller?
2. when I was able to bind everything in the past (through guided configuration) - 4 heating zones (1 HR92 each) and the Hot water, whenever I was starting the hot water wireless relay (via the controller) the Heating wireless relay was also switched on (both of them instantly) and when I was switching it on the Heating BRD91 was going off but the HW was still on.
Note: the two BDR91 are at least 7 meters away from each other.
Can anyone provide some feedback on what the issue might be in those cases
Comment