Activity Stream

I believe this is because of the expected behaviour of a typical blind motor which uses pulsed inputs. For example if the motor is moving in one...

Does the controller register a fault in the log if it cannot communicate with the HM80 after a while? Also the new manuals say that HM80 is now an...

So I wasn't going mad. Yes the boiler does seem to fire up just with the zone type kept at Mixing Valve. And like I said the Heat Demand shows up...

I had no issues with the HM80 and latest firmware but didn’t try to rebind it. I think I see what you mean, with the latest firmware if you try...

that problem sounds a bit like one that caused us a while ago to abandon the specific buttons we'd added to Cortex Mobile via a Menu object plus...

Managed to reconnect the service this morning.

Don't think I'll try geofencing today lol My car is in the garage anyway

I am assuming this is the right section to ask this! If I install a Worcester Bosch 8000 Life Combi am I right assuming I need an adaptor to use...

Thanks Karam - appreciate the update :) With this, I seem to be pretty much "there". I've setup a Motor Control object which I've assigned the...

Just received email notification that Evohome IFTTT service is offline. Could not reconnect for the moment.

OK I think I figured it out. It didn't quite work when I held both buttons down at the same time. But if I pressed the Close button first held it...

@kevinsmart what's the trick to get the HM80 bound with the WiFi Evohome controller? I have simply connected power to the HM80. It comes on with Led...

I guess we just await developments for a while. I just use the geofencing to switch to economy when I leave the house, or more accurately when my...

yes same here

Using the max setpoint to determine that DHW is being called for won't give the desired outcome because often the CH demand is also set to the same...

I’ve got my new system up and running with my Vokera boiler and it looks like I was wrong, there is no distinction between CH and DHW demands coming...

That's the thing. I have an EcoTec Plus 438, it doesn't even have the 24V inputs on the PCB. Even to get OT to work, I had to play with the terminal...

There's apparently a work around on the Plus System boilers - although i've never implemented it myself. How are you changing the set point using...

On the eBUS side there doesn't appear to be any indication of a difference between the two Heat Demands. Hence why I was surprised when @kevinsmart...

Does it work OK? At some point i'll probably be replacing my boiler with a Vaillant and wondered if it's worth the extra hassle. Did you manage...

Yes a VR33

What you using to do that out of interest? a VR33?

I have not seen these issues. But then again, I have an OT to eBUS converter between the OTB and my Vaillant Boiler. But low modulation of a boiler...

Somewhat unrelated to the Boillers listed in this thread, I have a feeling that something is going wrong with OT in my setup. Or more exactly that...

Motor relay output connections and a 'Busy' connection have been added to the motor control object. The former depend on the state of the control...

Unfortunately the only electrical connections in terms of control are through F connection (controlling CH and currently being initiated by BDR91)...

Yeah. It’s gone. Mine stopped working today. :( Reluctant to throw it in the recycling, but doubt prodding it is going to reveal anything...

Thanks, think I have sorted it now. I just removed the room/zone and then set it up again. They all seem to work, just need to see if the radiator...