Activity Stream

I've ordered the components for the next batch of devices. I expect to have everything by mid May and hope to release stock within a few days. ...

We had a few test devices that have been running for weeks and months continuously. So you'll be fine.

Huge thanks, although I eventually got my nanoCUL working it still regularly failed to transmit properly, so far today no errors at all.

Excellent, it's taken many years to get to this point.

Got mine and working perfectly with HA!

thanks very much :)

Now that these are starting to go out into the wild, I'll hook us up on to another thread to make sure people get up and running quickly.

There is a Notify me when product is back in stock) link against the Out of Stock icon. How do I tell the difference between the user names here and...

That’s one possible problem out of the way! My new Intergas is working fine. Domestic Hot Water is OK now I have reduced the mains water pressure...

Honeywell OpenTherm Bridge works fine with this model boiler. P.

Hi, what about the people who showed interest on this forum (like me)? I did not receive a reply on my request for a PM, and visited the shop...

The first batch has sold out. I only informed the people who had made stock requests on the shop site to give them first chance. I hope to have...

An update Put the ABV in place put a reducing tee 22mm down to 2 x 15mm out, one side going to immersion output from H/W motorised valve, other...

A thought. Is your Honeywell OpenTherm Bridge compatible with the ECO range? I know it is with the Xclusive range for Intergas designed the OT...

No idea then sorry. I just connected my bridge to the boiler and set the evohome to opentherm and then did the binding. Might be worth emailing...

There is no connector between 6 and 7, it's the first thing I checked before I connected the bridge. I also did a factory reset of the evohome unit...

Just looking at the manual for your boiler, you have removed the connector between terminals 6-7 as well as connecting the opentherm to terminals 11...

Do make sure that (a) you have deleted the reference to the old BDR91 and (b) in the Control Panel have selected OpenTherm as your option. Provided...

To close this one off: I got in touch with Honeywell to enquire about about obtaining replacement terminal blocks and, to be honest, wasn't expecting...

The VR66 is considerably bigger than I was expecting. And just like you said above, I was thinking "what a waste" - none of the functionality is...

One day I will dream up a use for the zone valve and the NTC sensor outputs in the VR65....I mean they are just sitting there doing nothing at the...

Nice one - thanks for confirming. So just to confirm for anyone else looking to do this, all that is needed to activate HW mode on the VR65/VR66...

D.22 = 1, means that HW mode has been activated. Plus you have the flashing tap, which means it's working. D.5 is just what the CH knob has been...

Hooked up the VR66 today - I think it's working! Just want to confirm though - how do you know the HW demand has been activated? I see the tap...

If it does connect, it will still say opentherm in the options until you change it. When I setup mine I connected the opentherm bridge to the boiler...

If it binded to it then it's basically received a signal and they've talked to one another. The Evohome unit is telling me just now that its...

I am not sure my evohome tells me it is receiving a signal from it. I am sure it just said it had binded to the R8810 receiver and the receiver just...

That's what I'm trying to do. I go through the process and then hit bind and the evohome says the bind signal was received properly. Thing is,.I've...