Register
Help
Remember Me?
What's New?
Activity Stream
New Posts
New Group Messages
New Events
Mark Forums Read
Forum
Advanced Search
Home
Activity Stream
If this is your first visit, be sure to check out the
FAQ
by clicking the link above. You may have to
register
before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Activity Stream
Filter
Sort By
Time
Show
Recent
Recent
Popular
Popular
Anytime
Anytime
Last 7 Days
Last 7 Days
Last 30 Days
Last 30 Days
All
All
Photos
Photos
Forum
Forums
Groups
Groups
New Activity (
)
Please reload this page to view the 200+ new activity items that have been created.
Older Activity
Today,
05:34 PM
morpheus
started a thread
No way to have the HR92 commanding the BDR91
in
Heating Control
Hi there, A friend of mine is not succeeding in setting up its unique HR92 commanding the BDR91. He has an evotouch in a room with radiators...
see more
0 replies | 0 view(s)
Today,
04:50 PM
morpheus
started a thread
Evohome : Simple / Multi Zone + heater valve / Zone valve
in
Heating Control
Hi there, I have an Evohome system with 8 zones defined and a total of 9 HR92's (2 of them are located in the same zone - living room), but I...
see more
0 replies | 1 view(s)
Today,
01:23 PM
AH_
replied to a thread
Evohome compatible with mix of HR91s and HR92s?
in
Heating Control
Thank you both. Very helpful replies! DBMandrake, could you point me at further reading regarding the HR91 performance & compatibility issues you...
see more
3 replies | 103 view(s)
Today,
12:22 PM
paulockenden
replied to a thread
Evohome compatible with mix of HR91s and HR92s?
in
Heating Control
A cable tie round the body might also work, and lot leave dried sticky if you want to remove it.
see more
3 replies | 103 view(s)
Yesterday,
09:58 PM
DBMandrake
replied to a thread
Evohome compatible with mix of HR91s and HR92s?
in
Heating Control
Yes, you can mix HR92 and HR91 on the same Evohome system - I had an HR91 for evaluation on my system for a while, however I didn't keep it as I...
see more
3 replies | 103 view(s)
Yesterday,
05:09 PM
AH_
started a thread
Evohome compatible with mix of HR91s and HR92s?
in
Heating Control
Hi, I've searched far and wide but haven't found anywhere that confirms the evohome system can have a mixture of both HR91s and HR92s connected to...
see more
3 replies | 103 view(s)
9th December 2019,
10:54 PM
AndyTkd
replied to a thread
HUE with dimmer
in
General Discussion
Thats Great, thanks Guyan Sounds like its worth trying this out for myself Do you know if there are any setup instructions for this on web...
see more
2 replies | 230 view(s)
9th December 2019,
08:57 PM
MrBoy
replied to a thread
What voice commands can I give Google Home for EvoHome heating?
in
Heating Control
I just get "sorry that mode isn't available for the <room>" Load of rubbish. In Google it says all my room thermostats are offline.
see more
3 replies | 260 view(s)
9th December 2019,
02:17 PM
guyank
replied to a thread
HUE with dimmer
in
General Discussion
Andy, I’ve done exactly this in 3 rooms. I use a Fibaro Dimmer 2 and retractive switch at the wall. I then use SmartThings to control all the...
see more
2 replies | 230 view(s)
9th December 2019,
12:44 PM
DBMandrake
replied to a thread
Evohome controller clock stopped
in
Heating Control
The egg timer just means it hasn't received any transmissions from the temperature sensor in the zone since the controller was rebooted, as they are...
see more
7 replies | 262 view(s)
9th December 2019,
09:12 AM
bruce_miranda
replied to a thread
New evohome FW - update WiFi 02.00.17.00 and Application 02.00.17.03
in
Heating Control
Wow, so it's now been 2 years since the last firmware and no new Evohome replacement products too. What's up Honeywell.
see more
374 replies | 106277 view(s)
9th December 2019,
12:02 AM
jb80
replied to a thread
New evohome FW - update WiFi 02.00.17.00 and Application 02.00.17.03
in
Heating Control
Email Resideo (Honeywell) at consumersupportuk@honeywellhome.com They can push the software update manually if you provide your MAC and CRC numbers.
see more
374 replies | 106277 view(s)
8th December 2019,
03:27 PM
AndyTkd
started a thread
HUE with dimmer
in
General Discussion
I know that Hue bulbs and other Smart Bulbs cannot be dimmed using a standard dimmer switch, because they reduce voltage to dim bulb which smart...
see more
2 replies | 230 view(s)
7th December 2019,
07:24 PM
anniesboy
replied to a thread
Evohome controller clock stopped
in
Heating Control
Thank for that information,I did notice that attempting to reset time had no effect. After ensuring the power jack was firmly inserted I ruled that...
see more
7 replies | 262 view(s)
7th December 2019,
06:48 PM
DBMandrake
replied to a thread
Evohome controller clock stopped
in
Heating Control
Lots of threads have covered this problem before - a search for clock stoppped should turn them up. ;) It's not loss of Wifi that causes it, it's...
see more
7 replies | 262 view(s)
7th December 2019,
11:32 AM
anniesboy
replied to a thread
Evohome controller clock stopped
in
Heating Control
Thank you,I will do just that if needed.
see more
7 replies | 262 view(s)
7th December 2019,
10:38 AM
sminkypinky155
replied to a thread
Evohome controller clock stopped
in
Heating Control
If it does happen again you will probably find that the controller is still showing as connected to your wifi. I've had to disconnect and enter the...
see more
7 replies | 262 view(s)
7th December 2019,
08:12 AM
paulockenden
replied to a thread
Den Automation has gone titsup
in
General Discussion
Yeah, but Earth is there for safety. I wasn’t convinced that “there’s no alternative” was a good reason to use it for power. I also suspect the...
see more
7 replies | 254 view(s)
6th December 2019,
10:52 PM
DBMandrake
replied to a thread
Den Automation has gone titsup
in
General Discussion
Yes it's a bit naughty.... however lighting circuits aren't typically RCD protected and if its just a few milliamps it's probably not an issue in...
see more
7 replies | 254 view(s)
6th December 2019,
02:04 PM
anniesboy
replied to a thread
Evohome controller clock stopped
in
Heating Control
Thanks for that thought, I did not notice if wifi was connected. As it is working OK at the moment I will leave alone but will check connectivity...
see more
7 replies | 262 view(s)
6th December 2019,
12:48 PM
sminkypinky155
replied to a thread
Evohome controller clock stopped
in
Heating Control
I believe that sometimes the unit loses contact with the servers, 7.15 would have been the exact time this happened.
see more
7 replies | 262 view(s)
6th December 2019,
11:30 AM
anniesboy
started a thread
Evohome controller clock stopped
in
Heating Control
I woke this morning to find only three radiators on,on looking at my controller clock it had stopped at 7.15am. I checked that jack plug was...
see more
7 replies | 262 view(s)
6th December 2019,
09:07 AM
DanD
replied to a thread
Evohome and OpenTherm Compatibility with Glow Worm Boiler
in
Heating Control
Hi, Unfortunately I think you're unlikely to find any information which clearly indicates compatibility and Glow Worm don't officially support...
see more
6 replies | 943 view(s)
5th December 2019,
09:16 PM
hallra
replied to a thread
Evohome and OpenTherm Compatibility with Glow Worm Boiler
in
Heating Control
Hi Dan, Thanks for replying to me, sorry it has taken me time to reply, I’m not very well, sometimes my health gets in the way of things. ...
see more
6 replies | 943 view(s)
5th December 2019,
07:21 PM
Drpepper
replied to a thread
Evohome controller multi comms faults.
in
Heating Control
Just made the modification above, manually opened CH switch, locked it and isolated electrics on it. BD91 for the CH now firing boiler direct. I...
see more
27 replies | 1001 view(s)
5th December 2019,
03:12 PM
paulockenden
replied to a thread
Den Automation has gone titsup
in
General Discussion
I was never happy about how Den lights witches were wired. They used Earth as Neutral. Other manufacturers *could* do that, but they don't. For...
see more
7 replies | 254 view(s)
5th December 2019,
02:58 PM
DBMandrake
replied to a thread
Den Automation has gone titsup
in
General Discussion
So the alternatives now for UK wiring compatible smart light switches are......Lightwave ? and....... ??
see more
7 replies | 254 view(s)
4th December 2019,
11:36 AM
paulockenden
replied to a thread
Den Automation has gone titsup
in
General Discussion
They had good WAF (wife acceptance factor). Or husband acceptance factor for one regular forum poster.
see more
7 replies | 254 view(s)
4th December 2019,
09:15 AM
Otto-Mate
replied to a thread
Den Automation has gone titsup
in
General Discussion
Yup, comments started appearing at the bottom of this post in October... ...
see more
7 replies | 254 view(s)
3rd December 2019,
09:44 PM
Drpepper
replied to a thread
Evohome controller multi comms faults.
in
Heating Control
It does seem to be an installer lottery... Anyway I have one that has a good rep lined up he's just busy as its that time of year. I'll have a...
see more
27 replies | 1001 view(s)
More Activity
No More Results
No Recent Activity
