Activity Stream

This has got to be the most severe bug that exists on the Evohome system today. I can't think of a bigger issue. The bug of not periodically...

Opposite way around for me. Normal results in cold rooms and radiators reluctant to actually heat up, partial works very well for me, I've been using...

I can confirm that this charging bug still exists in the 19.33 firmware. I fitted brand new rechargeable batteries several months ago and ensured...

1. Quieter radiator controllers 2. More zones 3. HomeKit support 4. Modern iPad app (not a tiny area in the middle of the 12.9" iPad screen that...

Mine is still on 02.00.17.03.

I am considering Intergas, but an Intergas system boiler with a vented or unvented tank driven by mains water pressure. I have in the last couple of...

My controller hasn't been updated yet - is it still being rolled out or has it been held up for some reason?

I tried to get a discussion going on this (Combi boilers to work with Evohome) but, unfortunately, it got sidetracked into an admittedly fascinating...

Hi All, Sorry for the lengthy post, I'm hoping someone on here might be able to assist with an issue I'm experiencing. I've had evohome for a few...

You could could consider a thermal store vented or unvented for supplying hot water at mains pressure. I assume if one does that you don’t need DHW...

In my new house, almost completed install, I’ve ditched the TMV and fitting a limit thermostat as a safety device.

2 single channel Drayton Wiser controllers should work in that situation I think. I have a 'comparable' system in that I have one large thermal...

Understood, I am really hoping that the manifold TRV now serves as a fail safe, rather than my only defence against 65C water being pumped round my...

Good stuff, look forward to hearing how you get on. The manifold will of course be fed with water between the HM80 min and max set temperatures.

We are looking to get our ancient Baxi Solo 2 PF 50 boiler replaced and after initially considering Worcester-Bosch, are now considering an Intergas...

I finally managed to find a brand new HM80 and the associated 20K NTC flow sensor for sale. I have no idea what the new solution for a mixer valve...

The bug that keeps the batteries within the control panel topped up has not been implemented. So by the time you need the backup of the batteries,...

Thanks. Will have a look.

Try this link and also within the thread Anniesboy original link...

Yes I also have a combi and whilst brilliant in many ways a bath does throw the heating !! I’ve got used to that so tend to have wide heat up times...

I had it set to normal. It had actually been working fine for a for a couple of weeks, just that for some reason it went wrong last night. Could be...

Have you got it set to normal or partial ? I found partial did have that sort of impact whereas normal really seems to work well for my property 😁

Cold Weather and just remembered why I disabled 'advanced load scaling' last year, went up to bed last night and all the bedrooms were freezing, well...

Wow, Electric zone was introduced almost 4 years ago now.

Must be old stock. Both of my new controllers had latest firmware pre-installed.

Not sure about that, I bought one two weeks ago and the firmware didn't have Electric Heating zone type support, had to contact support and they...

Cheers, bought a DST92E and will see how it goes before buying more for the other rooms

Nope, no difference. I've used both types - usually the one with just the thermostat but in one case I bought the pack which includes the relay as...

All mine bought from 5 years ago up until one replacement last year have firmware 1.01 as reported when the batteries are inserted.