Activity Stream

Thats Great, thanks Guyan Sounds like its worth trying this out for myself Do you know if there are any setup instructions for this on web...

I just get "sorry that mode isn't available for the <room>" Load of rubbish. In Google it says all my room thermostats are offline.

Andy, I’ve done exactly this in 3 rooms. I use a Fibaro Dimmer 2 and retractive switch at the wall. I then use SmartThings to control all the...

The egg timer just means it hasn't received any transmissions from the temperature sensor in the zone since the controller was rebooted, as they are...

Wow, so it's now been 2 years since the last firmware and no new Evohome replacement products too. What's up Honeywell.

Email Resideo (Honeywell) at consumersupportuk@honeywellhome.com They can push the software update manually if you provide your MAC and CRC numbers.

Thank for that information,I did notice that attempting to reset time had no effect. After ensuring the power jack was firmly inserted I ruled that...

Lots of threads have covered this problem before - a search for clock stoppped should turn them up. ;) It's not loss of Wifi that causes it, it's...

Thank you,I will do just that if needed.

If it does happen again you will probably find that the controller is still showing as connected to your wifi. I've had to disconnect and enter the...

Yeah, but Earth is there for safety. I wasn’t convinced that “there’s no alternative” was a good reason to use it for power. I also suspect the...

Yes it's a bit naughty.... however lighting circuits aren't typically RCD protected and if its just a few milliamps it's probably not an issue in...

Thanks for that thought, I did not notice if wifi was connected. As it is working OK at the moment I will leave alone but will check connectivity...

I believe that sometimes the unit loses contact with the servers, 7.15 would have been the exact time this happened.

Hi, Unfortunately I think you're unlikely to find any information which clearly indicates compatibility and Glow Worm don't officially support...

Hi Dan, Thanks for replying to me, sorry it has taken me time to reply, I’m not very well, sometimes my health gets in the way of things. ...

Just made the modification above, manually opened CH switch, locked it and isolated electrics on it. BD91 for the CH now firing boiler direct. I...

I was never happy about how Den lights witches were wired. They used Earth as Neutral. Other manufacturers *could* do that, but they don't. For...

So the alternatives now for UK wiring compatible smart light switches are......Lightwave ? and....... ??

They had good WAF (wife acceptance factor). Or husband acceptance factor for one regular forum poster.

Yup, comments started appearing at the bottom of this post in October... ...

It does seem to be an installer lottery... Anyway I have one that has a good rep lined up he's just busy as its that time of year. I'll have a...

This is what I did with my setup, Locked the CH valves open using the manual switch on the valves, electrically isolated them and had the BDR91 fire...

Never heard of them before! That's a shame. I'm looking to replace a couple of outdoor light switches (which are inside the back porch) with smart...

Hmmm, the one "certified evohome installer" that I dealt with was worse than a waste of space. If you want to try operating without the C/H zone...

Yes, a valid point to be fair. Reason one would be the CH one has failed so at least needs a new head, second would be one installer is telling me...

My dual controller Evohome system was part of a full replacement of boiler, rads (around 26, I forget the exact number), and all pipework - I chose...

Tbh as they are in an open plan utility room and a downstairs WC that don't need separate heating as they get it from surrounding space I'm pretty...