Activity Stream

Nope,another missed opportunity, even though the OTB is able to distinguish between CH and HW workloads, it doesn't do much with it. Except when...

So the TPI issue is probably sufficient to send me down the x-plan route. Out of interest, does the evohome opentherm implementation allow different...

I absolutely hate that TPI is built into the firmware of the BDR91. It should have been overrideable. Worse still the relay settings available in the...

Doesn't work well with Opentherm. I ended up changing my NC Motorised valve to a NO one as per the old system before the Firmware update. The...

Not that I can think of, the software now just gives existing installations the option. What we fought for though was the forced DHWP setting that...

Thanks. I guess that was what I was trying to determine. To make sure I have this correct. DHWP is a new feature in the latest firmware. Before that...

The Evohome now allows you to implement DHWP regardless of the way the system is piped. You could always implement DHWP with an X plan with a...

Is that true with x-plan? I thought in that case the CH loop opened when the DHW loop was closed. ie just one BDR91 on the DHW loop.

Being the guy who coded all this into Domoticz, I have some bad news. Evohome uses none of this information! Infact in the latest firmware, it didn't...

In order to use HW priority, you will need BDR91 controlling the HW and CH loops, in addition to your OTB that fires the boiler.

I just changed it as soon as the boiler had been installed. I dropped it down to around 12kW first. No change to efficiency and then dropped it the...

Having just had an Intergas boiler installed, with an OpenTherm bridge, I'm impressed with the amount of additional information that has appeared in...

Thanks again. That's something that I'll have to remember to revisit when the weather gets colder. My installer mentioned that the power required for...

I tried the flow at 60c but it was taking too long for a room to warm. 65c was better but still a time lag, noticeable on colder days. I settled on...

The data in the Fault Logbook device will tell you what the actual fault is. see...

I’ve set this up and get an email when there’s a fault but the message is always “ Fault Logbook Usage is 4 ”. I can’t get it to tell me what the...

He’s set the flow temperature to 65 but I doubt he’s changed many of the other defaults. He’s not experienced with Intergas. I’ve downloaded the...

My Intergas 36 was installed in February 2021. No problems and last check showed it was running at 99% efficiency. The Opentherm Bridge sits between...

Well, my Intergas Xtreme 36 has just been installed. I’m waiting for the full documentation to be returned after it’s been registered, and then I’ll...

A solution that works for me is to create a new dummy zone using the evohome controller itself as the zone temperature sensor, and the type set to...

Yes I am already on the post 2025 set up i.e. Single FTTP that does both Broadband and landline. No copper any more. And that allowed me to finally...

Me too, ordered back in early March ! FB

Sounds like it. It has been this way for businesses for some time now. A friend found it useful during lockdowns or when staff had to isolate. He...

Yes, the ability to connect a conventional PSTN phone directly to the phone line will be discontinued, but you'll still be able to connect it to a...

I take the point. I am spoilt I suppose not needing the landline. Broadband costs me £20 pm with 500 MPs and each mobile is £6.95. There may be...

Would be nice, if we had any mobile coverage. At least with the old fashioned landline we can still use the phone in a power cut - until, that is,...