Activity Stream

Reliance on an Internet feed for temperature was always going to run into these sorts of issues, especially with the lag involved in the update...

My OTGW sat unused for over a year and the moment I decide to sell it, because it made little sense to my setup, I could do with one - Typical isn't...

I’ve been thinking about Domoticz and was pleased to discover that there’s a version for Synology NAS, but then I discovered that it’s no longer...

In case this is of use to someone else ... It seemed that "signed decimal" lat/long for my location was working, but the data didn't update;...

It has just self corrected controller showing 3c and boost deactivated.

So previously, Evohome would request the boiler stats from the OTB every 5mins. It doesn't do that any more. It used to request the Control Setpoint...

Great. Might be useful to understand typical electricity consumption/costs too.

Bruce, how often does the Evohome controller communicate with the OTB? Maybe that frequency has changed and that influences how often the OTB reads...

The Evohome firmware upgrade cannot impact the frequency at which the OTB requests the boiler for the outside temperature. It could however be that...

My own system details here.

# Honeywell Jasper, HVAC? "08": {"type": "JIM", "name": "HVAC?"}, # Jasper equipment interface module "31": {"type": "JST", "name":...

From my previous house with Intergas boiler. The Intergas boiler returns fractional temperatures, its sensor was very accurate according to my...

So we think both 08: and 31: are Jasper products?

Very interesting. Could you please show me some more of these temperature messages, especially if you have the actual temperatures too. And...

Yes, that's right, approximately every 1m 45s. It's not OTGW initiated, it is coming from the OTB (T for Thermostat, B for Boiler): ...

I wrote the 'Dunno'. My best guess is that it is a Honeywell Jasper Stat TXXX: 2020-12-26T11:57:18.482643 082 I --- 31:012319 63:262142...

I'd have a fully assembled one.

Kevin, are you saying you have actually seen the OTB request the outside temperature ID: 1B from the boiler? I wonder why it does that thought. That...

It's worked well for me in both a radiator and now a UFH setup. I can hardly believe that the previous owner of my house had the UFH TMV set to 75C...

Out of interest Vaughn, what is your setup? I see myself eventually going down the GSHP route. My house was originally going to have one fitted but...

Stick an OTGW between the OTB and VR33? That should tell you whether the Domoticz->HGI80->OTB path is working, returning the same value. We know...

I really like the latest update,particularly the cold weather boost. Today I used the "new" eco setting for the first time which I have set to -1.5

It really wasn't. Or rather, wasn't meant to be.

I thought this thread wasn't for digs... ;)

BTW, I too catch this type of device with exactly that message. But in my case I know it is a neighbour because I know the IDs of relays and it isn't...

I am getting back data from my Outdoor sensor, which seems to change exactly in relation to the actual temperature but I can't make any sense of the...

I just love the fact that Evohome is still being supported / improved, despite the controller being a bit long in the tooth now.

I used to have, but when I added the pre-heat tank before my Intergas combi I added the special sensor for this, and that seemed to clash with the...

Try sending this using your HGI80, replace the xxxx with your own ID. And post what comes back. RQ --- 18:00xxxx 31:004811 --:------ 10E0 001 00