Activity Stream

We have proven that a low battery causes the offending device to send out garbled messages that overwhelms the radio channel. This then causes a...

The HRxx has no static memory of setpoints or schedules. It relies on the controller telling it what to do. So when you power it up, it defaults to...

I think you will need another Evo controller. ...

Yes, I fixed the worst offender by gently reforming the contacts, and I suspect I need to do the same to others. I didn't mention that before as I...

The tightness of the batteries in their compartment is a long know problem. Sometimes slightly behind a contact of you can makes them a better fit. ...

I'm a bit late to this - I've had similar issues in the past with a couple of zones, but only every now and then. Last time it happened, I went to...

Thank you for your help, though since I have an unvented cylinder I need to insert the probe into the cylinder. I actually worked out the solution...

I know its been a while, but I thought i'd reply to the post. So in my case, the engineer cut a small hole in the outer insulation of the tank and...

If you do you will have no emergency backup to heat the tank. I am sure someone here has done this. I just used the external sensor which was fine....

I have a similar situation with a Telford unvented cylinder. I am trying to work out where to install the Evohome insertion sensor probe. Should I...

EvoControl is now fully translated into German — the website at https://smartskills.tech/evocontrol shows screenshots and example commands in German...

Thanks. I am running at 70C with a 99% efficiency. Whilst the setting is 70C max it often drops down to below 40C for the flow temperature.

Its the boiler return temperature that determines the boiler efficiency and has to be down to ~ 55C before any condensing effect, 55C gives ~ 86%,...

Mine did not seem to learn and I found little or no difference when I switched Eco mode off, other than I suppose less gas consumed. I had it on for...

@filbert doesn't your boiler have some installer or diagnostic menu that allows you to see Return temperature. It's quote a key data point for the...

There is very little two way comms between the OTB and the controller. And that's a shame. Also I am not surprised that some values returned by the...

Unfortuately, I'm not sure how to check the return temp. Domoticz, via the OTB, lists it as a parameter but it's constantly showing 71.7 deg. I do...

That's such a disappointment! I thought Evohome was seeing and using all this information. I also wonder how much of the info shown is reliable? I'm...