Tab Content
  • gordonb3's Avatar
    12th January 2019, 11:06 AM
    I think one should consider the other possibility that the outages are not caused by Honeywell themselves but by outside parties, like hackers,...
    154 replies | 7341 view(s)
  • gordonb3's Avatar
    11th January 2019, 09:30 PM
    I don't use the official app. Not normally anyway. The logs are from a home automation project that I use to channel my commands.
    154 replies | 7341 view(s)
  • gordonb3's Avatar
    11th January 2019, 09:17 PM
    Ow!!! I actually just checked the temperature log. Investigating the application log it turns out the portal started refusing login (renewal) at...
    154 replies | 7341 view(s)
  • gordonb3's Avatar
    11th January 2019, 09:00 PM
    Quick catch... I did an override on two zones around 7:30 PM and the log shows that this override was in fact executed. The temperature in the two...
    154 replies | 7341 view(s)
  • gordonb3's Avatar
    2nd January 2019, 07:02 PM
    Ehhh... yes. If you use a BDR to control the UFH pump then you will automatically save on your electricity bill. This comes with the risk that the...
    26 replies | 7108 view(s)
  • gordonb3's Avatar
    2nd January 2019, 11:08 AM
    Well, yes and no. I have a loose HR92 lying in a cupboard that is configured in the Evohome controller to operate the UFH, so if I turn up the...
    26 replies | 7108 view(s)
  • gordonb3's Avatar
    2nd January 2019, 09:14 AM
    Found some additional info on that little box bottom-left in the image. It has three main functions: it will shut down the motor when the input...
    26 replies | 7108 view(s)
  • gordonb3's Avatar
    2nd January 2019, 08:44 AM
    Wasn't aware that I had. Also wasn't aware at the time that the pump normally uses that much electricity over the year. As the guys that came to...
    26 replies | 7108 view(s)
  • gordonb3's Avatar
    1st January 2019, 08:13 PM
    Had to look that up. Amazed to see they still sell passive stuff like that. I had my UFH installed about 8 years ago and the manifold itself is...
    26 replies | 7108 view(s)
  • gordonb3's Avatar
    26th December 2018, 09:20 PM
    So the app just updated the values about 20 minutes ago. Controller still does not show the new override I programmed since and just now the zone...
    154 replies | 7341 view(s)
  • gordonb3's Avatar
    26th December 2018, 08:28 PM
    Seems to be fubar-ed. It's now 20:21 and the app is showing me an override until 19:48 on one of my zones. I actually did set that override using the...
    154 replies | 7341 view(s)
No More Results
About gordonb3

Basic Information

Statistics


Total Posts
Total Posts
102
Posts Per Day
0.13
General Information
Last Activity
19th January 2019 12:09 PM
Join Date
6th December 2016
Referrals
0