Tab Content
  • smar's Avatar
    2nd February 2020, 10:54 AM
    Yes, I do have the separate zone valves/BDR91s, though I had previously disconnected the one for raditators, and left it in the open position (it had...
    15 replies | 868 view(s)
  • smar's Avatar
    1st February 2020, 02:56 PM
    Yes, that is what I had figured. Assuming that I don't have hot water priority, then I'm guessing that some of the benefits would be negated?
    15 replies | 868 view(s)
  • smar's Avatar
    1st February 2020, 02:55 PM
    Thanks and sounds good.
    15 replies | 868 view(s)
  • smar's Avatar
    1st February 2020, 09:32 AM
    Great, thanks. As you've had your OT bridge in place for a few years now, is it something you would recommend based on your experience (I have a...
    15 replies | 868 view(s)
  • smar's Avatar
    31st January 2020, 05:52 PM
    I've been thinking about adding OpenTherm to my setup. What problems are you encountering with the OT bridge? Is there somewhere where you are...
    15 replies | 868 view(s)
  • smar's Avatar
    31st January 2020, 05:47 PM
    I am using an arduino/CC1101 to monitor the messages and simply don't see messages from the CS92A when it stops working. If the issue was controller...
    72 replies | 3396 view(s)
  • smar's Avatar
    31st January 2020, 02:48 PM
    I'm using the insertion sensor and have the same issues described here. In fact, as advised by Honeywell, I have also put in thermal paste into my...
    72 replies | 3396 view(s)
  • smar's Avatar
    28th January 2020, 08:31 AM
    No, I didn't try that one. May give it a go at some point but as per @DBMandrake, I also think that there is an inherent design issue with these...
    72 replies | 3396 view(s)
No More Results
About smar

Basic Information

Statistics


Total Posts
Total Posts
47
Posts Per Day
0.06
General Information
Last Activity
Today 10:03 AM
Join Date
15th February 2018
Referrals
0