Hi
Evohome newbie - please go easy! And sorry if this has been asked before, I have searched but didn’t find a straight answer.
The evohome installation guide (photo below I hope) shows the controller being used like a standard Honeywell controller (eg: a CM927). I successfully bound the controller to the BDR91 relay, but I could not get a zone set up correctly. I set a zone (see photo) with the heating type as Zone Valve (also tried Rad Valve) and the sensor as the Evotouch. But the boiler keeps coming on, the relay trips even when the actual temperature is well above the setpoint.
Can anyone advise?
Thanks
TT
C37C9258-643D-4FF6-911E-4AC9A44B9A7F.jpg
image.jpg
Evohome newbie - please go easy! And sorry if this has been asked before, I have searched but didn’t find a straight answer.
The evohome installation guide (photo below I hope) shows the controller being used like a standard Honeywell controller (eg: a CM927). I successfully bound the controller to the BDR91 relay, but I could not get a zone set up correctly. I set a zone (see photo) with the heating type as Zone Valve (also tried Rad Valve) and the sensor as the Evotouch. But the boiler keeps coming on, the relay trips even when the actual temperature is well above the setpoint.
Can anyone advise?
Thanks
TT
C37C9258-643D-4FF6-911E-4AC9A44B9A7F.jpg
image.jpg
Comment