Hi guys,
I’ve had a 2 zone system running well for a year now in a new build house.
In review I replaced the existing stats for ground and 1st with BDR91 relays.
Main controller on Ground controls the ground relay and room stat on first controls First floor relay.
The time controller was removed and a HW BDR91 fitted to switch HW circuit, leaving existing wiring in place for HW after this.
The CH feed was merely connected through in the back as this is now controlled by the relays.
So the next step is I would like to swap over one zone to being controlled Solely by H92 radiator valves.
Can this be done by the addition of H92’s or will I need extra kit to make it work.
Ideally I’d like each room on the 1st floor to be totally independent so one rad can be run by itself on that floor independent of the ground floor.
I’m electrically qualified so no issues with wiring etc, but no plumbing, so the terminology sometimes confuses.
Any ideas?
I’ve had a 2 zone system running well for a year now in a new build house.
In review I replaced the existing stats for ground and 1st with BDR91 relays.
Main controller on Ground controls the ground relay and room stat on first controls First floor relay.
The time controller was removed and a HW BDR91 fitted to switch HW circuit, leaving existing wiring in place for HW after this.
The CH feed was merely connected through in the back as this is now controlled by the relays.
So the next step is I would like to swap over one zone to being controlled Solely by H92 radiator valves.
Can this be done by the addition of H92’s or will I need extra kit to make it work.
Ideally I’d like each room on the 1st floor to be totally independent so one rad can be run by itself on that floor independent of the ground floor.
I’m electrically qualified so no issues with wiring etc, but no plumbing, so the terminology sometimes confuses.
Any ideas?
Comment