That appears to be correct, I see the Warm Weather behaviour without icons so far.
My evohome system is running via opentherm control,bedroom 1,2 and three are at the moment following the warm weather function and are off,the colour on the evohome controller is grey but not showing any other icons.All other zones are starting to come online as per normal.
Sounds like warm weather shutdown is only useful on an OpenTherm system then, as a TPI system will already not fire the boiler until the heat demand is at least 10%. (Dependent on minimum on time and cycle settings)
Still don't have the update yet so I can only speculate how it will behave on a TPI system.
Have you seen any evidence yet of the outside temperature being exchanged between the OTB and boiler?
Warm weather is working on my system too today - all zones as showing as off currently. TPI based system.
We have discussed HW priority.
But what is HW heating state that appears to be another feature?
Ok, but would the boiler have been stopped anyway without the feature enabled due to heat demand of all zones being less than 10% ? Next time you see that condition, turn the feature off and see whether the boiler fires...
We've had warm weather today with rooms being near their set points without any help from the heating and my boiler has been off most of the day too, and I'm still on the old firmware. :)
You are right, when I checked the demand all zones were showing as 0% before - but i'm not sure if that was because the feature had kicked in and switched them to 'off' (They show as like you've set the system to 'Heating OFF') For instance the kitchen is set at 21oc, and was showing as 20.5oc room temp and showing as warm weather shut down. I suspect if i'd turned warm weather off this zone would have come back on (As there's two rads in there) I'll check next time when there's a low demand, not always easy to catch a 10% demand though!