Search:

Type: Posts; User: sminkypinky155

Search: Search took 0.00 seconds.

  1. Was on 'normal' load scaling, adjusted to partial...

    Was on 'normal' load scaling, adjusted to partial and immediately both went to 100%. Thanks for your help everyone.
  2. Anybody else having problems with the cold...

    Anybody else having problems with the cold weather boost function?

    This morning our lounge has a temperature of 16.5, with the outside temperature being 6 degrees. Setpoint normally 19, system has...
  3. Here's a strange one for Andy the Minion. We...

    Here's a strange one for Andy the Minion.

    We have a room (our room) in our setup that whenever the cold weather boost kicks in without fail receives a new set point 2 degrees higher than its...
  4. Replies
    7
    Views
    1,248

    If it does happen again you will probably find...

    If it does happen again you will probably find that the controller is still showing as connected to your wifi. I've had to disconnect and enter the details again to make it work.
  5. Replies
    7
    Views
    1,248

    I believe that sometimes the unit loses contact...

    I believe that sometimes the unit loses contact with the servers, 7.15 would have been the exact time this happened.
  6. My unit upgraded this afternoon.

    My unit upgraded this afternoon.
  7. The controller is showing actual room temperature...

    The controller is showing actual room temperature on the screen saver page - press the screen and the big figures are actual temperature, the smaller ones set temperature.

    The 92's communicate...
  8. That's right. If you buy the kit that includes...

    That's right. If you buy the kit that includes the BDR91 it will be pre bound to the controller. I see you have already ordered, good luck and don't forget to come back here if you have any problems,...
  9. Simply because swapping out is easier. I asked on...

    Simply because swapping out is easier. I asked on here for advice and Richard from evohome said all I had to do was take the face plate off and click the new one into place. There are no wires that...
  10. I went from a cm927 to evohome last September. ...

    I went from a cm927 to evohome last September.

    I must admit I had the same feelings as you, am I buying a gadget for the sake of it and will it save me money.

    I have to so so far that our gas...
  11. Replies
    10
    Views
    3,195

    Yes. High can set the evohome to away mode,...

    Yes. High can set the evohome to away mode, temperature is set at 15 degrees at default but that can be changed via the base unit.
  12. Replies
    5
    Views
    3,432

    I think it's possible you may be using the wrong...

    I think it's possible you may be using the wrong page of the instructions. Have you looked at page 22?

    The instructions you are using enables the system to have multiple rooms in one zone, eg all...
  13. Replies
    1
    Views
    1,235

    All sorted. I disconnected the controller from my...

    All sorted. I disconnected the controller from my internet connection and reconnected. It obtained the correct time briefly and then four minutes later obtained it again and has stayed correct since.
  14. Replies
    1
    Views
    1,235

    Clock stopped

    Our evohome controllers clock stopped this morning at 07.14, we noticed it at 07.45. Clock ha seen set for updates via wifi so I switched it to manual and entered the correct time. A minutes passed...
  15. Yep, just checked here and all back up and...

    Yep, just checked here and all back up and running.
  16. Replies
    3
    Views
    2,371

    Sounds like a very similar setup to mine as my...

    Sounds like a very similar setup to mine as my combo boiler has an integral bypass valve. Works like a dream, although today there is a big problem with the iOS and android apps not working, nor can...
  17. Still unable to register my device. I contacted...

    Still unable to register my device. I contacted Honeywell via Twitter and had a reply saying that the European based team will look into it. Will update here when I hear anything from them.
  18. Update: instead of leaving well alone I though...

    Update: instead of leaving well alone I though I'd try deleting and re adding my device as I had managed to log in via the web. Now seeing the same problem as emmeesse, so therefore I'm now fairly...
  19. You're not the only one having this problem! When...

    You're not the only one having this problem! When I access the app I am seeing the message "communication with the system has been lost". I've deleted the app from my phone and reset the Internet...
  20. Replies
    4
    Views
    3,395

    I'm all for something easier so that sounds good...

    I'm all for something easier so that sounds good to me!

    Thats all my queries for now, thanks again, now to order and install.

    cheers
  21. Replies
    4
    Views
    3,395

    Thanks for that top brake, though I think you've...

    Thanks for that top brake, though I think you've misread Drayton for Danfloss, will the supplied adapter still be suitable?.

    The boiler is a Potterton Performa 24 Eco HE which has an automatic...
  22. Replies
    4
    Views
    3,395

    Looking for smart thermostat advice.

    Hi

    I'm new to the forum which I stumbled across while researching all the different options for smart thermostats.

    In the last few weeks I've gone between Evohome, Nest, tado, Hive, Heat...
Results 1 to 22 of 25