Search:

Thanks for the suggestion.

I'm afraid that's too expensive, I've got to get the initial setup (i.e. proof of concept) running for less than £250, this would need to include 3 appliance modules...

I used to run an X10/Homeeasy home automation and security set up, this worked well, but without status values I was finding devices on when they should have been off etc. Plus it was awfully slow...

8 GU10 (3 pairs of increasingly better LED, 1 pair of CFL)
2 MR11 (we don't switch these on because can't replace with LED at the moment)
1 MR16 (High brightness LED)
2 Candles
2 Ultra-compact...

I've built an Atom based PC with 7" usb touchscreen for around half the cost of the cheaper touch screen, although haven't managed to get it to work over a network via usb->network converter. So I...

I could have sworn you have to have the unit switched to P to get it to forward all house codes. It's a bit irritating as in that mode anything transmitting on channel 1 seems to trigger it. Although...

I have a limited z-wave setup, but found I was getting exactly the same usb reboot symptoms, I found 2 solutions to the problem

1) Go into control panel->system->hardware delete the z-wave usb...

I used to see the problems you were getting, but they've more or less dissappeared since the house was rewired (with the exception of one room), this was going from one single socket ring to about 8...