Search:

Type: Posts; User: therealfronty

Search: Search took 0.01 seconds.

  1. Replies
    3
    Views
    103

    Just do the RF check for that zone, it will send...

    Just do the RF check for that zone, it will send a message and report it as unsuccessful (because the HR92 didn't respond), then I'm pretty sure it gives you the option to delete it. Try that first....
  2. Replies
    3
    Views
    103

    Hi, I have done this, you definitely don't need...

    Hi, I have done this, you definitely don't need to create a new zone, have you found the installer menu, press and hold the settings button. I can't remember the exact procedure but I remember doing...
  3. Wiring bdr91's into a sundial wiring centre

    So, I have evohome and still use my existing programmer to control the hw, but I do have the hot water kit, just haven't wired it in yet. I used the room stat terminal block to wire in the ch bdr91...
  4. Replies
    5
    Views
    303

    Gotta be honest, the only thing I use custom for...

    Gotta be honest, the only thing I use custom for is to set every zone to 35 degrees so all valves open when I need to drain down the system.
  5. Replies
    29
    Views
    13,293

    I bought a load of HR92s off ebay that came with...

    I bought a load of HR92s off ebay that came with that black valve adaptor thing. The standard size is m30 x 1.5 but when I tried to screw a couple on they just wouldn't screw down. On closer...
  6. Replies
    10
    Views
    543

    Just curious, which batteries do you use? I've...

    Just curious, which batteries do you use? I've got duracells in mine but even those have leaked on occasion in different devices.

    I wonder if there is something that can be done in an attempt to...
  7. Replies
    3
    Views
    286

    I don't think there's any settings to change it,...

    I don't think there's any settings to change it, there's not much you can do with the controls on the front panel. However I have found what looks like an extra jumper in the Viessmann wiring...
  8. Replies
    3
    Views
    286

    Evohome TPI and pump overrun

    Been doing a bit of reading about TPI. Currently when my old roomstat turns off the boiler after CH demand is satisfied my pump shuts down immediately and there is no overrun.

    When I replace the...
  9. Replies
    12
    Views
    646

    Lots of interesting discussion points! :-) ...

    Lots of interesting discussion points! :-)

    Currently I have two rads in the living room where the old wall mounted roomstat is, neither currently has a TRV (as you'd expect). The roomstat is still...
  10. Replies
    12
    Views
    646

    Old room stat in the living room is still wired...

    Old room stat in the living room is still wired into boiler so that is the only thing that can actually call for heat, but hr92's successfully turn off the rads upstairs during the day (and the...
  11. Replies
    12
    Views
    646

    Not sure what load scaling is, I've got firmware...

    Not sure what load scaling is, I've got firmware 02.00.19.33 and have disabled both cold start/warm boost or whatever it's called straight away as didn't want any clever nonsense going on.

    Anyway,...
  12. Replies
    12
    Views
    646

    Can't get one zone to heat up

    Hi, I've had evohome hr92 trvs on most of my radiators for about a week now, on the whole it's been working well except I just can't get my daughters bedroom to warm up fully, even if I have her...
  13. This is actually how my central heating was...

    This is actually how my central heating was configured when I bought my house in 1997 - the house was about 20 years old and came with an ancient floor standing boiler that was on it's last legs,...
  14. Ah that makes sense.

    Ah that makes sense.
  15. Replies
    215
    Views
    93,237

    What a fascinating thread! I've only had evohome...

    What a fascinating thread! I've only had evohome in my house for a few days so still tweaking the schedules, already I noticed some noise from the bedroom HR92 when it opens the valve at 6am but to...
  16. Hmmm this is interesting, new user here and just...

    Hmmm this is interesting, new user here and just seen this thread, I also have a Grundfos Alpha2 pump like this, also a Viessmann 26kw boiler, except mine is y-plan open vented, and I have 13...
  17. Oh that's interesting, I had read that people had...

    Oh that's interesting, I had read that people had had problems like this and then ended up running the wizard (which I think wipes out your current settings/schedules etc.?). So thanks for the tip!
    ...
  18. New Evohome user + new firmware + which TRV body?

    Hi all, new evohome user here, I picked up a gen 3 controller and 11 x HR92s off ebay, also came with the boiler relay and hot water kit, so lots of fun to be had.

    Already got the HR92's working...
Results 1 to 18 of 18