Search:

Type: Posts; User: olektrolek

Search: Search took 0.03 seconds.

  1. same here. it actually makes mobile app useless....

    same here.
    it actually makes mobile app useless.
    this is not fair - mobile access is included in the price you pay. now youre abandoned by Honeywell with pants down.
  2. temperature measured by evotouch is bit higher than usual?

    Hi,
    I observed the last two days the temperature measured by evotouch is around 25 degrees, which I am sure it is not real room temperature.
    We have unusual weather here in Dublin with temps around...
  3. Replies
    11
    Views
    1,043

    ACTUATOR in this case is a HR92 zone needs two...

    ACTUATOR in this case is a HR92

    zone needs two bindings: sensor and actuator(s).

    so far you have bound the sensor from HR92.

    it might be confusing that you need to bind the same device twice...
  4. so that would be answer for my question - both...

    so that would be answer for my question - both HR92s show temperature measured by evotouch.
  5. Temperature displayed on HR92 with evotouch controller as a sensor

    Hi,

    i have zone configured with two valves HR92 and evotouch controller acting as temp sensor for this zone.
    i configured valves to display current temp reading rather than setpoint - "avanced"...
  6. that is very good suggestion

    that is very good suggestion
  7. yes - DTS is just remote temp sensor for the...

    yes - DTS is just remote temp sensor for the zone.
    all the decisioning still made at the evohome.
  8. maybe I was not clear - you need to have the...

    maybe I was not clear - you need to have the Evotouch controller for driving boiler and valves.

    then DTS92 can be paired as remote sensor for zone.

    and evotouch controller starts/stops boiler...
  9. you pair it as a remote sensor in zone settings....

    you pair it as a remote sensor in zone settings. works very well - and offers pretty much the same as HR92.

    readings from the DTS92 are transferred to evotouch so you can see the temperature...
  10. for me this happens where I modify zone setup,...

    for me this happens where I modify zone setup, either by adding, removing or renaming rooms.
    reinstalling helps.
    iOS app.
  11. Hot water icon in evotouch - is it really working as expected?

    I observe that icon for the "heating" state displays always in selected hours regardless if boiler is really working, ie. if there is demand for heat or not.

    example:
    water heating set to ON...
  12. I normally use HR92 as a sensors for the zones....

    I normally use HR92 as a sensors for the zones. they are accurate too.
    in one zone I set up DTS92 as the location of the HR92 is in the "warm" corner and readings were not accurate.
  13. I observe similar. the sensor in the controller...

    I observe similar.
    the sensor in the controller must be very sensitive.
    but it should go back to room temp in hour or so.

    also I think that charging batteries and working display adds up some...
  14. Hi everybody, have been silent reader of this...

    Hi everybody, have been silent reader of this forum for while.
    Owner of evohome + 12 TRVs + DHW kit here.

    finally got my privileges sorted with forum admins ;)


    what wanted to say is that I...
Results 1 to 14 of 14