Search:

Type: Posts; User: JCK

Search: Search took 0.00 seconds.

  1. [QUOTE=garymtitley;40669]Thanks for the detailed...

    [QUOTE=garymtitley;40669]Thanks for the detailed reply,very informative and understood.My boiler has a two speed pump that runs on speed one at a certain kw setting and on speed two over a certain kw...
  2. I have hr92 on all rads and on my kitchen plinth...

    I have hr92 on all rads and on my kitchen plinth heater , the plinth heater fan only operates when approx 45 deg detected in the plinth heater, therefore it comes on only when hr92 opens and calls...
  3. Replies
    103
    Views
    21,494

    I don't under stand the logic of the Spirovent to...

    I don't under stand the logic of the Spirovent to prevent corrosion . I understood (perhaps incorrectly) the corrosion is mostly by dissolved oxygen not by free air , Spirovent cannot remove...
  4. My controller did not seem to be getting updated...

    My controller did not seem to be getting updated so emailed Honeywell support for the from the Total connect web page , and gave them my:
    a) email address ,
    b) Evohome controller MAC Code and...
  5. Replies
    13
    Views
    8,639

    Thanks, i have just taken the action to sort out...

    Thanks, i have just taken the action to sort out the batteries and at last i can move the controller without beeps after 5 mins .
  6. Replies
    27
    Views
    25,803

    Is the ATAG IC economiser compatible with...

    Is the ATAG IC economiser compatible with Opentherm as can be used by Evohome or is it another locked down control version only allowing use of their One system for non on/off control.
  7. Convert Combi to unvented cylinder setup with Evohome

    Hi, I self installed the evohome system (thanks Evohome shop) on my Combi Boiler system with 12 radiator zones last December, it has been excellent and I found it easier to install than I...
Results 1 to 7 of 7