Search:

Type: Posts; User: DBMandrake

Page 1 of 20 1 2 3 4

Search: Search took 0.01 seconds.

  1. Mine has been on partial for a few weeks now too....

    Mine has been on partial for a few weeks now too. It certainly helps a lot, (vs full) however I'm still sometimes unable to get heat from a single zone (usually the bathroom) when other zones have no...
  2. Same problem here with my bathroom radiator and I...

    Same problem here with my bathroom radiator and I raised this issue with Andy further up thread...

    I had to drop down load scaling from full to partial because I was completely unable to get the...
  3. Replies
    9
    Views
    295

    The low battery icon within zone squares on the...

    The low battery icon within zone squares on the home screen was there in previous non-beta firmware.

    Strange that you're not seeing a message in the fault log though - I have always had a low...
  4. To be fair, the old way where turning up an HR92...

    To be fair, the old way where turning up an HR92 manually in heating off mode still worked (but didn't show anything on the controller) was always a bug or oversight.

    A lot of people were unhappy...
  5. How did you use the App to revert your firmware ?...

    How did you use the App to revert your firmware ? I haven't seen or heard any way to do that...
  6. Replies
    4
    Views
    171

    FYI, The YT87RF and DTS92E are both available...

    FYI,

    The YT87RF and DTS92E are both available with or without a bundled BDR91, so you don't need to build up a large supply of unwanted BDR91's.... :cool:

    The cost saving of the thermostat only...
  7. Yes a much discussed "known bug", check out the...

    Yes a much discussed "known bug", check out the beta firmware thread for more discussion about it.

    On the plus side Andy the Minion has already said quite some time ago that the problem is known...
  8. Same here - with the hot weather we've been using...

    Same here - with the hot weather we've been using a Custom action configured to 5C (discussed in another thread) to keep the heating off but still overrideable for towel drying etc, so whenever any...
  9. I wonder if Andy the Minion has any news for us...

    I wonder if Andy the Minion has any news for us on when the next firmware release might be out ? Whether a release candidate of a public release or a further beta release ?

    Looking back in this...
  10. Replies
    8
    Views
    317

    I concur - if your flow temperature is shared...

    I concur - if your flow temperature is shared between radiators and hot water reheat as it is in my system (no flow temperature "boost" for hot water reheat) then the flow temperature should be a...
  11. I think you might be confused - locking an HR92...

    I think you might be confused - locking an HR92 (so that it says blocked when you turn the dial or press the button) is something you have always had to do from the zone configuration in the...
  12. Replies
    3
    Views
    237

    It shows the first HR92 which was bound to the...

    It shows the first HR92 which was bound to the zone, which is also the one that would be used as the only sensor if you switched the zone back to single room zone. If you're not sure which one it is...
  13. Adaptive load scaling does not do what you...

    Adaptive load scaling does not do what you apparently think it does. It does not cause additional "stop/start" cycles in any significant way.

    TPI (Time proportional integral) has been an integral...
  14. Replies
    2
    Views
    217

    If you're referrig to the "OFF" setting directly...

    If you're referrig to the "OFF" setting directly on an HR92 when turning the dial (not just setting it to 5C) then yes this is the expected behaviour.

    OFF tells the HR92 to completely ignore the...
  15. Ok, good to hear. Yes I did notice a slow...

    Ok, good to hear.

    Yes I did notice a slow integral action but it still wasn't enough to allow the boiler to actually come on. Don't get me wrong, I understand what the algorithm is trying to do, I...
  16. Replies
    18
    Views
    967

    The problem with the Eco quick action is it can't...

    The problem with the Eco quick action is it can't be used in conjunction with the Day Off quick action. And during the lockdown our system is on permanent Day Off mode when it isn't on heating off...
  17. The replacement valve arrived yesterday so I got...

    The replacement valve arrived yesterday so I got the head swapped over and wired back in. Two things I noticed since then, both expected:

    1) No more rooms going over temperature during hot water...
  18. Hi Andy, Can you confirm whether the load...

    Hi Andy,

    Can you confirm whether the load scaling bug I reported earlier in the thread (with load scaling preventing frost protection working) is a known bug or has been addressed (or at least...
  19. Replies
    18
    Views
    967

    By "current" firmware do you mean the regular...

    By "current" firmware do you mean the regular firmware or the beta firmware ?

    In summer during the day when I want everything off I usually just use the Heating Off action, as this allows me to...
  20. Do you really expect a company like Honeywell to...

    Do you really expect a company like Honeywell to pre-announce upcoming hardware that would replace the current generation Evohome ? :)

    The "Osbourne effect" springs to mind... :D
  21. Another thing to consider is that with the...

    Another thing to consider is that with the original firmware you could ADD hot water priority with a very simple wiring change (interconnecting the hot water and heating relay contacts) but with hot...
  22. Not sticky here - mechanically it seems fine, but...

    Not sticky here - mechanically it seems fine, but the motor windings have definitely gone open circuit.
  23. Don't hold your breath. I think we'll either see...

    Don't hold your breath. I think we'll either see forced hot water priority as it is now in the Beta, or they'll pull the feature entirely. I'm not holding much hope of seeing an on/off setting.
  24. Yep, got exactly the same complaint here, but...

    Yep, got exactly the same complaint here, but with the bath, (shower is electric) she started running a bath, turned up the radiator before getting in the bath and at the end of the bath cold...
  25. Replies
    4
    Views
    272

    Battery level messages are sent from the HR92...

    Battery level messages are sent from the HR92 once every 24 hours so its no surprise that it would appear at the same time each day.

    Do you have any other HR92's in the same zone or wall sensors ?...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4