Search:

Type: Posts; User: DBMandrake

Page 1 of 20 1 2 3 4

Search: Search took 0.01 seconds.

  1. Laggy outdoor temperature strikes again tonight....

    Laggy outdoor temperature strikes again tonight.

    For the last few days I've been using cold weather boost to boost the living room and dining room 0.5C with low outside temperatures and it has...
  2. Will those testing here see another beta more...

    Will those testing here see another beta more representative of the final version before it goes out to the masses so that the various fixes can be independently verified ?
  3. Replies
    5
    Views
    196

    Yep, working with 15mm and 22mm is a breeze...

    Yep, working with 15mm and 22mm is a breeze compared to the smaller stuff. I converted my gravity hot water system to S-Plan which meant cutting out some of the old pipe work and running quite a bit...
  4. Well spotted, yes this is new. As the value is...

    Well spotted, yes this is new.

    As the value is named "Load scaling rate of rise" when you go into it then I'd say yes it's related to load scaling :)

    Mine are all set to 3.0C as well and the...
  5. Replies
    5
    Views
    196

    I feel your pain. Counting draining and refilling...

    I feel your pain. Counting draining and refilling it took me a full day to replace the valve bodies (and lockshield valves) of my 9 radiators with Valencia's - I have the added complication that most...
  6. Replies
    9
    Views
    177

    Is it smaller than a DTS92E ?

    Is it smaller than a DTS92E ?
  7. Replies
    9
    Views
    177

    The hole on the back you're referring to just...

    The hole on the back you're referring to just goes into the battery compartment - there is no sensor in there.

    I've disassembled one of mine for repair twice (our 3 year old broke the screen off...
  8. The problem with the outdoor sensor is it was...

    The problem with the outdoor sensor is it was grossly over priced. When I first looked in 2015 (before I discovered it wouldn't work with the WiFi model of controller I was buying) I seem to recall...
  9. Has anyone worked out what criteria the warm...

    Has anyone worked out what criteria the warm weather saver function takes into account ? I have it enabled on 6 zones, outside temperature reported on the Evotouch is 13C, most of my zones are at...
  10. I've noticed some anomalies too, I think there...

    I've noticed some anomalies too, I think there may be a delay on re-evaluating whether cold weather boost applies as conditions change.

    I had two rooms scheduled to 21C with cold weather boost...
  11. Believe it or not that isn't hocus pocus, but a...

    Believe it or not that isn't hocus pocus, but a workaround to a different issue (phantom override) that has been there for a long time. (Not related to the current beta firmware) Quite a bit of...
  12. This morning the lag of the internet reported...

    This morning the lag of the internet reported temperature is hillariously bad...

    I have cold weather boost enabled on two zones (0.5C boost) to test it out, it's now 10:45am, my own weather...
  13. The beta firmware gave it a good long charging...

    The beta firmware gave it a good long charging session but it will be a month or two before I see whether it keeps them topped up or not.

    The issue I used to see on all previous firmwares is that...
  14. Another thing I'm interested to see is whether...

    Another thing I'm interested to see is whether the beta firmware fixes the issue where the controller lets the batterries run down and/or does not charge them completely when it is always left on the...
  15. I've had this happen to me on only one of my...

    I've had this happen to me on only one of my zones this morning during the optimal start period. (Kitchen showing 30C)

    I'd like to point out though that this is not just a display error on the...
  16. I'm also waiting to see whether this improves...

    I'm also waiting to see whether this improves with the beta firmware. Some debugging I did several weeks ago with packet capture of the comms between the CS92A and Evotouch to my surprise suggested...
  17. Or a strap on cylinder thermostat falling off the...

    Or a strap on cylinder thermostat falling off the side of the cylinder...
  18. Are you sure it's a manual override triggering...

    Are you sure it's a manual override triggering it, and not that it's just a large heat demand from a zone ? In my case the hot water started reheating when the heat demand dropping but while the...
  19. I think by then the heat demand for the zone had...

    I think by then the heat demand for the zone had reached zero, yes. I have to wonder if this was originally a feature but later decided to be a bad idea ?
  20. Thanks. Yes I had one manual override (the...

    Thanks. Yes I had one manual override (the bathroom) active at the time. Bit of a weird bug!

    The hot water did eventually fire up before I removed the override though.
  21. Update: 25 minutes after the home screen first...

    Update: 25 minutes after the home screen first claimed to be reheating the hot water the hot water relay has finally clicked on and the boiler relay demand on the system summary page has gone to 100%...
  22. Having some problems with hot water control now....

    Having some problems with hot water control now. :(

    I'm aware of the change to hot water priority and earlier in the day I tested a couple of hot water reheat cycles and they worked as expected -...
  23. That will be the load scaling feature - looks...

    That will be the load scaling feature - looks very similar to what I just reported in my frost protection post.

    If you have a boiler relay the minimum on-time sets the minimum amount of boiler...
  24. I've done a little bit of testing on this today...

    I've done a little bit of testing on this today and discovered a bug with frost protection. Well, you might call it an unintended interaction rather than a bug I suppose, but the end result is it...
  25. If I remember right window open mode being active...

    If I remember right window open mode being active is "reported" the same way in the API - eg the set point shows as 5C with follow schedule. Even the iPhone app doesn't know the difference between...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4