Search:

Type: Posts; User: anniesboy

Search: Search took 0.00 seconds.

  1. Replies
    2
    Views
    52

    On the controller,press and hold "settings",press...

    On the controller,press and hold "settings",press green tick,then press "system summary.
  2. Replies
    356
    Views
    31,586

    Make sure the power jack is pushed fully home,I...

    Make sure the power jack is pushed fully home,I had two lost/restored notices. It turned out to be jack not fully pushed in.
  3. Replies
    3
    Views
    250

    I think I have resolved the problem,it was caused...

    I think I have resolved the problem,it was caused by a poor connection to the base station.
    Most likely because the engineer who installed the smart meters moved the controller in order to site the...
  4. Replies
    3
    Views
    250

    The thing was after power was restored every...

    The thing was after power was restored every thing worked as normal.

    However this morning heating failed to come on.
    I discovered the time to base station clock had stopped,tried to reset but it...
  5. Replies
    3
    Views
    250

    Evohome faults

    I had smart meters for gas and electricity installed yesterday.

    I noticed shortly after the installation a fault showed (mains low) followed two minutes later by (restore).

    What does this...
  6. Replies
    356
    Views
    31,586

    It is now up and running ,for now

    It is now up and running ,for now
  7. Replies
    356
    Views
    31,586

    My app is also saying planed maintenance try later

    My app is also saying planed maintenance try later
  8. Replies
    4
    Views
    380

    This is a completely new installation,the boiler...

    This is a completely new installation,the boiler was put in the loft in order minimize lifting of flooring etc.
    I have a decided to get a loft ladder installed,I am glad to hear the relay can be...
  9. Replies
    4
    Views
    380

    Not S or Y plan, it is system boiler with no hot...

    Not S or Y plan, it is system boiler with no hot water provision, that is provided by an immersion heater.(thats another story)

    I have ten rads with eight zones, ( 9 hr92s ) and one with standard...
  10. Replies
    4
    Views
    380

    Evohome wireless relay

    I have a newly installed system
    It was only used initially to enable plumbers to test everything was OK.
    Yesterday I decided to turn it on only to find I was getting no heat at all ,I realised it...
Results 1 to 10 of 10