Found the percentage demand but no outside temperature
http://i67.tinypic.com/208wsj6.jpg
Type: Posts; User: lorcanjc
Found the percentage demand but no outside temperature
http://i67.tinypic.com/208wsj6.jpg
Mine updated as well but haven't noticed any changes on the controller
Conrad connection to Evohome seems to be permanently down now
However it does recognise new zones that I setup yesterday so must not have lost all interface
I was just trying the Conrad service out.
It recognizes all my zones but the only options are to get the #LatestValue and no option to create a graph.
When I return the latest value everything...
What do you mean by that?
Thanks for all the advise. I have set the water to constant off to be safe.
Not 100% sure what I should do next
It was an electrican who fitted it for me :)
The switch and fuse and both for the immersion. I think the electrican just replaced the old time clock in the circuit with the BDR91
I have a Y plan system with just hot water on or hot water and heating. I currently have a manual valve beside the boiler where I can switch between these two.
Could I replace the manual valve with...
Thanks for that went with using the Evohome controller as the single thermostat for the house.
One other question. I have bound the hot water temperature sensor and a BDR91 to the hot water...
I recently purchased Evohome for all the radiators in my house plus a hot water control.
However, while I thought I might be able to self install the wiring was too much for me and all my...
Considering automating my entire heating system.
The house has 16 radiators all with traditional TRVs. Two rooms have 3 radiators so 12 zones in total if I have each room as a single zone but...