Search:

@smar. What firmware are you running. If my FIFO branch do you have OT?

Do you have an OT module in your system?

If so are you seeing messages?

Which code are you running on the nano?

Somewhat lucky there, it runs the length of the loft and then goes down the corner of a bedroom which is above a garage. Hid the run through that room by adding a very narrow stud+plasterboard to...

See my comment above


My boiler is in the loft on one side of the house. My UFH is on the ground floor on the other side. It' couldn't be further away


That's irrelevant. The Controller...

For clarification the feed/return for the UFH in my system branches near the boiler close to the CH zone valve. It's not part of the rad loop.

I had a phantom zone

I deleted the location on the Honeywell Server and added it back again and all was well.
(I read this somewhere on one of the threads)

For what it's worth my original system was s-plan DHW + CH with zone valve for each driving boiler.

A couple of years ago I added a 2 zone UFH in an extension

The UFH controller (not H/well)...

Just got back from a longer than expected trip to Dublin (thank you, Beast from the East and Emma)

I've only got the RX side of the code changes working so far but think I'm seeing fewer problems...

@dty's evofw2 requires minimal changes.

I had to modify config.h and Makefile and write a new hw/<target>.h file

Since your stick has a different adapter board between the nano and cc1101 it's...

That's effectively what my stick is as well. The only difference being the carrier board used to attach the CC1101 to the nano. That's the bit that's not obviously available to buy separately or...

@TomJ

yes mine is running at 16MHz.
Can run the USB comms at 115200 (tested for a few minutes at 250000!)

I don't have an OT module so can't comment on those problems

I'm looking to see if...

@dty

I've got the nano plugged into my pi and I've set up ser2com

Running Domoticz 3.8153 on Synology.

How do I connect the "HGI80"?
I can't work out how to set up the "serial port"...

I've only been able to log for a few days but so far all the messages from the controller setting the broadcast period look like this
--- I --- 01:140959 --:------ 01:140959 1F09 003 FF0898...

So it appears TX was working all the time ;)

I think the problem was that nothing else was prepared to do RX.

Scanning my RX log I came across an interesting feature around 4 am every day.
All...

@dty it appears you're exceeding your stored private message quota :-)



I'm currently running Domoticz on a Synology and I have all the USB ports in use :-( Planning to switch it to a pi I've...

I've just bought myself one of these
[https://www.smarthome-agentur.de/produkt/nanocul-868-mhz-premium-aktuelle-fw-ftdi-cc1101-sma-transceiver-cul-stick-fuer-fhem/ ~42 euro delivered in 2-3 days...