Search:

Type: Posts; User: DBMandrake

Page 1 of 20 1 2 3 4

Search: Search took 0.01 seconds.

  1. Same here - with the hot weather we've been using...

    Same here - with the hot weather we've been using a Custom action configured to 5C (discussed in another thread) to keep the heating off but still overrideable for towel drying etc, so whenever any...
  2. I wonder if Andy the Minion has any news for us...

    I wonder if Andy the Minion has any news for us on when the next firmware release might be out ? Whether a release candidate of a public release or a further beta release ?

    Looking back in this...
  3. Replies
    8
    Views
    223

    I concur - if your flow temperature is shared...

    I concur - if your flow temperature is shared between radiators and hot water reheat as it is in my system (no flow temperature "boost" for hot water reheat) then the flow temperature should be a...
  4. I think you might be confused - locking an HR92...

    I think you might be confused - locking an HR92 (so that it says blocked when you turn the dial or press the button) is something you have always had to do from the zone configuration in the...
  5. Replies
    3
    Views
    195

    It shows the first HR92 which was bound to the...

    It shows the first HR92 which was bound to the zone, which is also the one that would be used as the only sensor if you switched the zone back to single room zone. If you're not sure which one it is...
  6. Adaptive load scaling does not do what you...

    Adaptive load scaling does not do what you apparently think it does. It does not cause additional "stop/start" cycles in any significant way.

    TPI (Time proportional integral) has been an integral...
  7. Replies
    2
    Views
    205

    If you're referrig to the "OFF" setting directly...

    If you're referrig to the "OFF" setting directly on an HR92 when turning the dial (not just setting it to 5C) then yes this is the expected behaviour.

    OFF tells the HR92 to completely ignore the...
  8. Ok, good to hear. Yes I did notice a slow...

    Ok, good to hear.

    Yes I did notice a slow integral action but it still wasn't enough to allow the boiler to actually come on. Don't get me wrong, I understand what the algorithm is trying to do, I...
  9. Replies
    17
    Views
    815

    The problem with the Eco quick action is it can't...

    The problem with the Eco quick action is it can't be used in conjunction with the Day Off quick action. And during the lockdown our system is on permanent Day Off mode when it isn't on heating off...
  10. The replacement valve arrived yesterday so I got...

    The replacement valve arrived yesterday so I got the head swapped over and wired back in. Two things I noticed since then, both expected:

    1) No more rooms going over temperature during hot water...
  11. Hi Andy, Can you confirm whether the load...

    Hi Andy,

    Can you confirm whether the load scaling bug I reported earlier in the thread (with load scaling preventing frost protection working) is a known bug or has been addressed (or at least...
  12. Replies
    17
    Views
    815

    By "current" firmware do you mean the regular...

    By "current" firmware do you mean the regular firmware or the beta firmware ?

    In summer during the day when I want everything off I usually just use the Heating Off action, as this allows me to...
  13. Do you really expect a company like Honeywell to...

    Do you really expect a company like Honeywell to pre-announce upcoming hardware that would replace the current generation Evohome ? :)

    The "Osbourne effect" springs to mind... :D
  14. Another thing to consider is that with the...

    Another thing to consider is that with the original firmware you could ADD hot water priority with a very simple wiring change (interconnecting the hot water and heating relay contacts) but with hot...
  15. Not sticky here - mechanically it seems fine, but...

    Not sticky here - mechanically it seems fine, but the motor windings have definitely gone open circuit.
  16. Don't hold your breath. I think we'll either see...

    Don't hold your breath. I think we'll either see forced hot water priority as it is now in the Beta, or they'll pull the feature entirely. I'm not holding much hope of seeing an on/off setting.
  17. Yep, got exactly the same complaint here, but...

    Yep, got exactly the same complaint here, but with the bath, (shower is electric) she started running a bath, turned up the radiator before getting in the bath and at the end of the bath cold...
  18. Replies
    4
    Views
    262

    Battery level messages are sent from the HR92...

    Battery level messages are sent from the HR92 once every 24 hours so its no surprise that it would appear at the same time each day.

    Do you have any other HR92's in the same zone or wall sensors ?...
  19. As you say a replacement head turns out to be...

    As you say a replacement head turns out to be more difficult to find and considerably more expensive than the whole thing (how pointless) so I ended up just ordering an entire valve for <50 with...
  20. Replies
    4
    Views
    262

    How many bars does the battery indicator on the...

    How many bars does the battery indicator on the HR92 report ? If it's less than a full three bars with new batteries try increasing the tension on the battery contacts in the bottom of the...
  21. Cold weather boost only applies when the outside...

    Cold weather boost only applies when the outside temperature is 10C or more lower than the set point. So in my zones that are set to 21C CWB kicks in when the outside temperature drops to 11C or...
  22. Funnily enough, and quite relevant to this...

    Funnily enough, and quite relevant to this conversation, my central heating zone valve failed just yesterday, discovered when I woke up to a cold house.... :( It's a Honeywell V4043 and is less than...
  23. Andy, Through this thread in response to some...

    Andy,

    Through this thread in response to some of the issues found such as the manual zone override postponing hot water reheat you've stated "yes we're aware of this, it will be fixed in the...
  24. Yes, adjusting the dial on an HR92 while the...

    Yes, adjusting the dial on an HR92 while the system is in heating off mode will cause the boiler to come on and that radiator to heat up.

    If the system is in heating off mode, that manual override...
  25. Replies
    31
    Views
    1,227

    Has anyone running the current beta firmware...

    Has anyone running the current beta firmware experienced a hot water comms issue since updating to the beta ?
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4