Search:

Type: Posts; User: Christo

Search: Search took 0.00 seconds.

  1. Replies
    0
    Views
    167

    Evohome dual HW

    Hi, I have a fairly large Evohome installation with 2 controllers. It's currently on a large oil boiler, and at times eg. in the summer when few people are around, it's better to use the electric...
  2. Day schedule over-ride

    Use case scenario: In bed on a Sunday morning planning the day on the iPhone...

    We're going to be out all morning, so leave it as it is until 12 when we get back for lunch (let the optimiser work...
  3. No propagation of measured temp across a zone: slave units instead

    This is a UI consistency glitch I think, but when HR92/UK units are set to display measured temperature, they actually seem to display the temperature of the master unit, not the temperature of the...
  4. The HR92UK thermostat knob goes the wrong way

    Another point:

    The HR92UK thermostat knob goes the wrong way. I have just installed my first HR92UK, as well as my first HR92, to go with a load of HR80UK and a few HR80 units which appeared on...
  5. I haven't yet played with it, but I understand it...

    I haven't yet played with it, but I understand it is limited to just one device rather than a family of them. Maybe useful as proof of concept for future development. Or just for tinkering.
  6. This is true, and it also helps with the mobile...

    This is true, and it also helps with the mobile device power draining issue that comes with using GPS. However houses take time to warm up, and I would imagine most people's fence perimeter would be...
  7. Now on my 3rd generation, having started with 4x...

    Now on my 3rd generation, having started with 4x CMzone units and 18 HR80s, and this keeps getting better. I am sure it has paid for itself many times over, with an annual heating bill in the...
  8. Replies
    2
    Views
    2,690

    One other thing. Only the Evotouch is bound, and...

    One other thing. Only the Evotouch is bound, and that may be why I get almost no red flashes ever.
  9. Replies
    2
    Views
    2,690

    You may have found some of this already, but here...

    You may have found some of this already, but here are a few thoughts, as I currently run 1x Evotouch and 2x CM67z with a total of 11 zones. Previously I used 4x CM67z units, and the red flashes were...
  10. Replies
    9
    Views
    8,503

    I have spoken to Honeywell who confirm that a...

    I have spoken to Honeywell who confirm that a HR80 unit version 2.02 will not work with the new Evohome controller, but that 2.03 and higher will work.
  11. Replies
    9
    Views
    8,503

    Thanks for this, but I have a mix of 2.02 and...

    Thanks for this, but I have a mix of 2.02 and 2.03. Can you be specific about which versions are known to work?
Results 1 to 11 of 11