Search:

Type: Posts; User: killa47

Page 1 of 5 1 2 3 4

Search: Search took 0.01 seconds.

  1. Well at least I got the automatic acknowledgement...

    Well at least I got the automatic acknowledgement email so I shall live in hope!
  2. After being told by ally53 that responsibility...

    After being told by ally53 that responsibility for roll out is with the "connected team" which will initially be released "to a small percentage of the Evo population", I emailed the Resideo...
  3. I have now received a PM response from ally53 in...

    I have now received a PM response from ally53 in which he confirmed the following:
    " firmware is in approval stages for general release. Once approved, this will be a staged process which will be...
  4. Agree with all your comments. It's a pity...

    Agree with all your comments. It's a pity Honeywell/Resideo haven't been as smart as they could have been in maintaining/updating/improving the Evohome system.
    I think if it wasn't for the shared...
  5. I sent a PM to ally53 a few days back asking him...

    I sent a PM to ally53 a few days back asking him exactly that question but not heard anything back yet. [The post by ally53 14th December refers]
    I asked 27th January if any forumites had received...
  6. It usually takes up to an hour for some more...

    It usually takes up to an hour for some more distant radiator TRVs to re-connect (handshake) with the controller. Some zones quicker than others but very rare for any zone to be still trying to...
  7. My two penneth's worth is that if it wasn't for...

    My two penneth's worth is that if it wasn't for the likes of DBMandrake and other contributors who freely offer their unstinting detailed advice and knowledge - Honeywell/Resideo would be in deep pig...
  8. Since ally53 advised back in mid-December that...

    Since ally53 advised back in mid-December that the new release would be rolled out gradually . . . . . has anyone actually received the updated firmware WITHOUT having requested it via the trial...
  9. Replies
    31
    Views
    2,602

    Try this link and also within the thread...

    Try this link and also within the thread Anniesboy original link
    https://www.automatedhome.co.uk/vbulletin/showthread.php?6255-Why-is-my-evohome-controller-beeping&highlight=controller+batteries
  10. Replies
    31
    Views
    3,451

    All points well said, CT1. I think there's lots...

    All points well said, CT1. I think there's lots of Evohome users on your wavelength here.
  11. HR92 shows hourly battery failure on controller

    One of my HR92s has started showing a battery low warning screen. When I check the faults page, there is often one battery warning approximately every hour (a minute or so different each time) yet...
  12. Replies
    28
    Views
    5,910

    I have a WB Greenstar 40CDI boiler, similar to...

    I have a WB Greenstar 40CDI boiler, similar to yours, and used to have continual cycling issues. Eventually I arranged for WB to install a later version main PCB, which reputedly (per internet...
  13. Replies
    28
    Views
    5,910

    Other thoughts - is the pump under-sized for the...

    Other thoughts - is the pump under-sized for the system or equally is the boiler under-sized, i.e. number of radiators @ various BTU ratings matching boiler output.
    If the boiler was under-sized and...
  14. Replies
    28
    Views
    5,910

    I run my condensing Worcester boiler at 70C flow...

    I run my condensing Worcester boiler at 70C flow temp (sometimes 72C when it's colder outside), so you could increase yours a tad.

    Also, is the sitting room one of the furthest rooms from the...
  15. Further to DBMandrake's detailed graph and...

    Further to DBMandrake's detailed graph and explanation, I did re-check the HR92 valve position which when showing 46%, the corresponding demand at the controller was 11% - perfectly matching the...
  16. Thanks DBMandrake for a comprehensive response,...

    Thanks DBMandrake for a comprehensive response, as always.

    I will check out your various suggestions tomorrow when can experiment some more.

    I did have the Kitchen/Conservatory originally set...
  17. Apologies for late response due to weekend...

    Apologies for late response due to weekend arrangements.

    Just checked again this morning with TRV showing 23C. Controller shows demand of 9%. HR92 shows valve position is 0. Kept checking for...
  18. Yes, the HR92 is set to display measured...

    Yes, the HR92 is set to display measured temperature. These temps show during the daytime, often when my wife is at work - and I don't do any cooking at all in the day.

    The kitchen is in an open...
  19. Strange regular 2C over setpoint temp reading on Kitchen HR92

    I keep getting a regular 23C temperature read on the kitchen HR92 when the setpoint temp is 21C. Wondering if the reading is being skewed because the radiator is a 2 metre tall vertical type?

    Any...
  20. Replies
    17
    Views
    5,424

    Just to complete the evolving picture re CS92...

    Just to complete the evolving picture re CS92 battery life - My batteries have lasted just less than 2 1/2 years since installation and are still going.

    I suspect the frequency of on/off set...
  21. Replies
    11
    Views
    4,479

    No I just wanted to make sure you had cleared...

    No I just wanted to make sure you had cleared previous bindings for the BDR91 before re-binding, otherwise you create multiple bindings.
  22. Replies
    11
    Views
    4,479

    You say you rebound. Did you clear all previous...

    You say you rebound. Did you clear all previous bindings before new bindings.
  23. Strange happening re zone comms fault when clearing fault notifications

    Yesterday I had a couple of comms faults on two zones - not that unusual given size of house. The controller was showing a little red exclamation symbol against these two zones which implied the...
  24. Replies
    18
    Views
    4,743

    Same thing happened to me, step son turned off...

    Same thing happened to me, step son turned off the ensuite HR92 and it threw me for a couple of days.

    But DBMandrake, you're saying be aware it (HR92) disables frost protect in OFF mode - surely...
  25. Also be aware that some rooms, if they are either...

    Also be aware that some rooms, if they are either without two or more external walls, tend to retain heat often above the set point. I have a house bathroom which is always the highest overnight...
Results 1 to 25 of 104
Page 1 of 5 1 2 3 4