I've recently tried to install a Sunvic TLX 7501 room thermostat and although this seemed simple enough - it is not switching on the heating. The unit 'clicks' when a temerature above the ambient temp is selected, but the boilier doesn't respond. Previously, I had a manual type Sunvic thermostat which would only turn on the heating when the temperature was turned down rather than up. THere are only two wires - red and black and a yellow/green earth - so I can't see what the problem is - unless I need a different type of thermostat? The old one that preceeded the SUnvics was an old brown and silver Honneywell unit. Any ideas?
New Room Thermostat problem
Collapse
X
-
Re: New Room Thermostat problem
if there's no flame i'm guessing it's the stat,
there's a small tag between the batteries and the battery connections have you taken this out ?
i'll have a look for some instructions for the stat ,but i'm shure you have to cut a link in the back of the stat.
Comment
-
-
Re: New Room Thermostat problem
mmmmm dunno
the instructions are here,
i think i'd take out and re-place the batteries then press and hold any key for 5 secs ?
Comment
-
Comment