Micromodule addresses

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts
  • youngmac
    Automated Home Lurker
    • Nov 2006
    • 1

    Micromodule addresses

    I am wondering if anyone knnows how to completely clear micromodules in order to put in a new address. I can set mine a few times and then they seem to stop accepting addresses. I had them set on a higher address and now need to reset to a lower address but I cannot get them into setting mode any longer.

    Thanks
    Owner, Total Home Systems
  • toscal
    Moderator
    • Oct 2005
    • 2061

    #2
    Re: Micromodule addresses

    Depending on the type of micro module there is either a small switch on the unit which you press with a small screw driver for about 3 seconds. If it doesn't have this switch then you need to switch the state of the module 5 times to get it into program mode. Once this is done then just send the address to the unit twice. Then if you want it to work with all lights on or all off then just send each of these commands twice. As far as I know there is now way to do a factory reset.
    As a side note you can't use a computer and a CM11 or CM12 to send the commands. Don't know why.
    IF YOU CAN'T FIX IT WITH A HAMMER, YOU'VE GOT AN ELECTRICAL PROBLEM.
    Renovation Spain Blog

    Comment

    Working...
    X