Being a DIY novice I have run into an unexpected problem with my combi boiler.
I removed a rad from the system for a few hours decorating. upon reintroducing the rad to the loop I found that when all the valves were switched back to ON the rad did not refill.
The pressure shows 0; so obviously a problem, however I cannot fathom how to reintroduce the lost water to the system.
If anyone knows anything about this please help me. Seems silly to need an engineer whenever you do some decorating.
I removed a rad from the system for a few hours decorating. upon reintroducing the rad to the loop I found that when all the valves were switched back to ON the rad did not refill.
The pressure shows 0; so obviously a problem, however I cannot fathom how to reintroduce the lost water to the system.
If anyone knows anything about this please help me. Seems silly to need an engineer whenever you do some decorating.
Comment