Tweet
Hi everyone. Hope your having a good bonfire night.
The problem i'm having with my system is that the hot water is working fine, but when I try turning on the central heating from the boiler itself, as I dont have a external controler (just a timer on the boiler) the heating kicks for for afew seconds the pipe warms up then it stops :cry: . It shows a fault of x2 (t's) back to back. Two lower case t's back to back.
As anyone please got any ideas on this? Not to sure if its a setting that need changing or a link that might need putting in. If you look at page 8 on this manual:
I think it might need a link on the diagram 226 with the big (M) there is link at the moment in the last 2 blocks.
Thanks for any help anyone can give and hopfully warm me up
Cheers
Paul
The problem i'm having with my system is that the hot water is working fine, but when I try turning on the central heating from the boiler itself, as I dont have a external controler (just a timer on the boiler) the heating kicks for for afew seconds the pipe warms up then it stops :cry: . It shows a fault of x2 (t's) back to back. Two lower case t's back to back.
As anyone please got any ideas on this? Not to sure if its a setting that need changing or a link that might need putting in. If you look at page 8 on this manual:
I think it might need a link on the diagram 226 with the big (M) there is link at the moment in the last 2 blocks.
Thanks for any help anyone can give and hopfully warm me up
Cheers
Paul