My question is about the X10(2nd) load lamp micromodule (2 wire, no need for neutral connection), as sold on automation@home.
I do have a couple of lamps that I want to add to my present X10 system by making use of micromodules. These lamps do not have the neutral wire running at the location of the switch.
The difference has been defined by the supplier(Kevin Lo) as follows;
1)3 Wire 's X10 signal sensitive is 25mV , 2 Wire 's X10 signal sensitive is 100 mV
2)2 Wire during dimming will have "Buzz" sound , but 3 wire didn'thave any sound
Since I can't interpretate the 25 vs 100 mV I would like to know if anybody has experience with these modules ?
I would like to make sure these modules work in a home-environment before I decide to buy a couple of these modules.
Thanks in advance.
I do have a couple of lamps that I want to add to my present X10 system by making use of micromodules. These lamps do not have the neutral wire running at the location of the switch.
The difference has been defined by the supplier(Kevin Lo) as follows;
1)3 Wire 's X10 signal sensitive is 25mV , 2 Wire 's X10 signal sensitive is 100 mV
2)2 Wire during dimming will have "Buzz" sound , but 3 wire didn'thave any sound
Since I can't interpretate the 25 vs 100 mV I would like to know if anybody has experience with these modules ?
I would like to make sure these modules work in a home-environment before I decide to buy a couple of these modules.
Thanks in advance.
Comment