Hi,
can anybody tell me what happens when there is a power failure using the ActiveHome software to program the CM11, but I power the PC off when finished.
Having just invested in a small starter system (Starting off with Christmas Light Control) i wondered if the system returns to the same state as it was before the failure. if so do the internal timers set on the modules also re trigger or do all the lights that were on, come back on.
Also, I have found that the Prolific USB device supplied with the CM11 locks up, I changed it for another Prolific USB to RS232 device with two serial plugs on it (9 Pin), bought a couple of months back from a USB online shop, so far it has been working for an hour which is more than the supplied lead does.
Regards
Mirv
can anybody tell me what happens when there is a power failure using the ActiveHome software to program the CM11, but I power the PC off when finished.
Having just invested in a small starter system (Starting off with Christmas Light Control) i wondered if the system returns to the same state as it was before the failure. if so do the internal timers set on the modules also re trigger or do all the lights that were on, come back on.
Also, I have found that the Prolific USB device supplied with the CM11 locks up, I changed it for another Prolific USB to RS232 device with two serial plugs on it (9 Pin), bought a couple of months back from a USB online shop, so far it has been working for an hour which is more than the supplied lead does.
Regards
Mirv
Comment