I have purchased the "One Load Appliance Micro Module" (X10-2267) from automated@home and all works ok or at least until it locks up. The device controls my landing light. I've noticed that when I turn an upstairs light on or off occasionally the landing will go off. Switching the landing light on/off or sending x commands has no affect. I have to go to the fuse box and turn the power off and on to the light circuit. Once the device is reset all is ok until the next time. Sometimes it works for minutes sometime for days. I mentioned this the automated@home and they sent me a new device however the new device also locks up. I sent another mail to Kevin but now I get now reply.
Anybody else had a similar problem or not? There is no way the device should do this unless it has a: design fault; a build fault or I've wired it up incorrectly (which hopefully is a bit of a long shot). Please don't blame interference/noise or a weakness in X10 devices.
Anybody else had a similar problem or not? There is no way the device should do this unless it has a: design fault; a build fault or I've wired it up incorrectly (which hopefully is a bit of a long shot). Please don't blame interference/noise or a weakness in X10 devices.
Comment