I seem to be struggling to set up my door connections properly. I have a recessed magnetic door switch connected to a DRB module digital input and have assigned the relevant device connection within cortex. Plan view shows the door opening and closing as intended and occupancy is inferred correctly. The problem however is the room object behaviour menu is not showing a must be occupied "jail" state when the door is closed and motion is detected inside the room.
I have another room with just a single Idratek PIR module and nothing else. Adding a virtual door object (i.e. one not assigned to a digital input switch) on its own and simulating door opening and closing I can get the must be occupied state to report correctly.
Anything I may be overlooking that would cause this behaviour?
I have another room with just a single Idratek PIR module and nothing else. Adding a virtual door object (i.e. one not assigned to a digital input switch) on its own and simulating door opening and closing I can get the must be occupied state to report correctly.
Anything I may be overlooking that would cause this behaviour?
Comment