Hi, I've had an SW10G sitting on shelf for couple of years and finally after having a load of building work on my house have decided to use it. So, last week put screen up in new room and connected up the SW10G to control it.
It works, controlled from PC or IR7243, up and down no problem. However, it seems totally inaccurate on the time, which controls the drop. At first I thought it only stopped when the screen was at its max. But I could hear the unit switch off. So, I tried some short drops (about 1/4 the screen height). Over about a dozen or so, up and downs the screen gradually openned further and it close position got a bit lower, maybe six inches.
I'm actually reasonably happy, but anyone seen this and any suggestions how to sort? I checked in the archive and saw there have been problems in the past but I dont think they were exactly what I'm seeing, but could not guarantee.
robin
It works, controlled from PC or IR7243, up and down no problem. However, it seems totally inaccurate on the time, which controls the drop. At first I thought it only stopped when the screen was at its max. But I could hear the unit switch off. So, I tried some short drops (about 1/4 the screen height). Over about a dozen or so, up and downs the screen gradually openned further and it close position got a bit lower, maybe six inches.
I'm actually reasonably happy, but anyone seen this and any suggestions how to sort? I checked in the archive and saw there have been problems in the past but I dont think they were exactly what I'm seeing, but could not guarantee.
robin
Comment