Following on from my thread >>HERE<<, could anyone with either an Infinite Prime or Marmitek ProGuard 800 alarm who also is using X10 try the following for me:
1. Confirm that HA is enabled (menu [963]);
2. Switch the panel off at the mains for 1 second, then switch it back on;
3. See what happens.
This isn't long enough to trigger the AC LOSS system alert, but in my case the panel then sends an Off X10 command to every unit on my housecode
I don't know if this is deliberately (mis-)programmed in the firmware or if I have a faulty X10 module.
My hardware and software versions are (menu [710]) HW C0 SW 01.05
1. Confirm that HA is enabled (menu [963]);
2. Switch the panel off at the mains for 1 second, then switch it back on;
3. See what happens.
This isn't long enough to trigger the AC LOSS system alert, but in my case the panel then sends an Off X10 command to every unit on my housecode
I don't know if this is deliberately (mis-)programmed in the firmware or if I have a faulty X10 module.
My hardware and software versions are (menu [710]) HW C0 SW 01.05
Comment