Hi, i hope you can help. I am an electrician & aim to build a house in the near future & hope to use the idratec system.
I will be wiring the power sockets in the house as a radial system & not the traditional ring main. This will enable a lot more control over the house automation. This will be similar with the lighting for each room to be on its own circuit.
I will end up with around 50 circuits & will be looking to monitor each circuit for power usage.
Question is! What’s the best way to do this?
I was possibly thinking of QAI-001 4 Way Analogue Input unit & connect to 50 ct’s (Coil transformers) But presumably i would be looking at 50 ct’s & 13 x QAI-001 to do it this way, or am i going down the wrong path.
Open to any suggestions. (It all needs to be logged so i can look back over data. )
Cheers,
Chris.
I will be wiring the power sockets in the house as a radial system & not the traditional ring main. This will enable a lot more control over the house automation. This will be similar with the lighting for each room to be on its own circuit.
I will end up with around 50 circuits & will be looking to monitor each circuit for power usage.
Question is! What’s the best way to do this?
I was possibly thinking of QAI-001 4 Way Analogue Input unit & connect to 50 ct’s (Coil transformers) But presumably i would be looking at 50 ct’s & 13 x QAI-001 to do it this way, or am i going down the wrong path.
Open to any suggestions. (It all needs to be logged so i can look back over data. )
Cheers,
Chris.
Comment