Blind Control

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts
  • Graham
    Automated Home Lurker
    • Mar 2004
    • 4

    Blind Control

    I'm trying to figure out how to setup blind control in Cortex before my modules arrive. The plan is to use DRH's to control the blind motors (which have 4 cables - earth, neutral and 2 lives [brown & black]). I've added a DRH to Cortex along with a Motor Control, connected a QBI to Open/Close the Motor Control, but I don't seem to be able to make it work.

    Does the network side of Cortex have to be running for this simulation to work?

    Thanks in advance
    Graham
  • Karam
    Automated Home Legend
    • Mar 2005
    • 863

    #2
    Yes the network needs to be running. If you visit Tools | Network Supervisor | Service tools and click on Disable all network nodes you may then be able to run your test network and see what happens using simulated key presses.

    Comment

    Working...
    X