Hi all,
I've made up my plans for how/ where and what i'm going to be using for my install and am about to place the order for all my phase 1 gear, but i was just wondering if there would be any problems with the following ...
I'm planning to buy 2 of these enclosures (20 Way CU). I will also be usig the flush mounting kit for these (Clicky).
In one of them I plan to run 4 x QRI002 and the other will have 3 x QLD001. Will I have problems with the units over heating and/ or premature failure due to heat?
Thanks in advance,
Nad
I've made up my plans for how/ where and what i'm going to be using for my install and am about to place the order for all my phase 1 gear, but i was just wondering if there would be any problems with the following ...
I'm planning to buy 2 of these enclosures (20 Way CU). I will also be usig the flush mounting kit for these (Clicky).
In one of them I plan to run 4 x QRI002 and the other will have 3 x QLD001. Will I have problems with the units over heating and/ or premature failure due to heat?
Thanks in advance,
Nad
Comment