Hi all,
My SC9000 seems to be playing up. Some of the signals from X10 connected devices are not reaching my server. they were ok before, but now, its hit or miss if they get through.
As an example, if I set the alarm, it used to send out a B1 ON, and when alarm was switched off, a B1 OFF. However, now, some of the B1 commands are not being picked up.
I would suggest I can rule out the wiring as its only the sending out that has the problem. Commands to all other X10 devices is working correctly, but just not the commands out of the SC9000. Yet as far as I can tell, everything else on the SC9000 is working as it should.
Anybody seen this behaviour on a SC9000 before? Any suggestions?
Jaffa
My SC9000 seems to be playing up. Some of the signals from X10 connected devices are not reaching my server. they were ok before, but now, its hit or miss if they get through.
As an example, if I set the alarm, it used to send out a B1 ON, and when alarm was switched off, a B1 OFF. However, now, some of the B1 commands are not being picked up.
I would suggest I can rule out the wiring as its only the sending out that has the problem. Commands to all other X10 devices is working correctly, but just not the commands out of the SC9000. Yet as far as I can tell, everything else on the SC9000 is working as it should.
Anybody seen this behaviour on a SC9000 before? Any suggestions?
Jaffa