Good morning all.
I've got a PLT (ceiling mounted) in our bedroom and am thinking about puttng a DFPH02 (wall mounted) in there too. Which got me thinking (along with a few other theads i have read on here) about is it possible to use the average reading of two or more sensors and if so how do you do it?
I'm not sure if i've made my self clear on this but I'll try and explain a bit more. At the moment I use the light level from the PLT to say if I need to have the ligt on or not and the same for the temp reading for heating. So if you have two (or more) sensors, is it possible to gain an average value for light and temp and use that value to assess lighting and heating requirements?
As always, any thoughts are most welcome.
Thanks,
Nad
I've got a PLT (ceiling mounted) in our bedroom and am thinking about puttng a DFPH02 (wall mounted) in there too. Which got me thinking (along with a few other theads i have read on here) about is it possible to use the average reading of two or more sensors and if so how do you do it?
I'm not sure if i've made my self clear on this but I'll try and explain a bit more. At the moment I use the light level from the PLT to say if I need to have the ligt on or not and the same for the temp reading for heating. So if you have two (or more) sensors, is it possible to gain an average value for light and temp and use that value to assess lighting and heating requirements?
As always, any thoughts are most welcome.
Thanks,
Nad
Comment