I have one of the new ActiveHome Pro units (CM15A) and have found three problems so far, two of which are major.
First, when I turn my computer on, a "B-1 ON" signal is transmitted during the POST operation even before the system has started to boot. "B" is my monitored house code.
Next, after that, no sensors or other remotes are recognized until I unplug the unit and leave it unplugged for several minutes before plugging it in again.
After that, there is usually a delay of up to several seconds before a received signal is transmitted to the power line.
Finally, the Find Other Computers is showing several other housecodes in use in addition to the three I use. I have checked all the neighbors and none are using any X-10 devices.
I have reported this to X-10 but haven't gotten any response yet.
First, when I turn my computer on, a "B-1 ON" signal is transmitted during the POST operation even before the system has started to boot. "B" is my monitored house code.
Next, after that, no sensors or other remotes are recognized until I unplug the unit and leave it unplugged for several minutes before plugging it in again.
After that, there is usually a delay of up to several seconds before a received signal is transmitted to the power line.
Finally, the Find Other Computers is showing several other housecodes in use in addition to the three I use. I have checked all the neighbors and none are using any X-10 devices.
I have reported this to X-10 but haven't gotten any response yet.
Comment