Hi all,
I'm new to using X10 and I thought I'd get myself a couple of basic bits to begin with. I bought a 2026UK dimming lamp module and a remote control (KR22). I was about to buy a 4022UK IR receiver and see if I could get these three working together as a start.
However, looking at the instructions for the 2026UK, I see that an X10 controller is needed to program the code. I had assumed I would be able to do the programming using the remote control via the receiver, but now I'm thinking I'm going to need a plug-in controller (or mini-controller) to do the programming. Is this right? Or is there a way I can get it programmed without buying a plug-in controller?
Thanks very much in advance for any help that can be offered!
I'm new to using X10 and I thought I'd get myself a couple of basic bits to begin with. I bought a 2026UK dimming lamp module and a remote control (KR22). I was about to buy a 4022UK IR receiver and see if I could get these three working together as a start.
However, looking at the instructions for the 2026UK, I see that an X10 controller is needed to program the code. I had assumed I would be able to do the programming using the remote control via the receiver, but now I'm thinking I'm going to need a plug-in controller (or mini-controller) to do the programming. Is this right? Or is there a way I can get it programmed without buying a plug-in controller?
Thanks very much in advance for any help that can be offered!
Comment