Tweet
I recently upgraded to version 3.308 however after trying it out for a few weeks it appears to have an issue when using extended codes.
If a module that uses extended codes (ie LM12 wall dimmer) is programmed and added to a macro - when the macro runs - the light doesn't turn on.
I can see the codes in the Activity Monitor so the macro is running but the light does not respond.
If I turn the light on by using the GUI - the light comes on.
Also if I run the macro by clicking on it - it works. (I think this is because clicking on a macro runs the macro from the PC rather than the interface).
Changing the module to an old style one - it works ok.
I have also tried using the Extended codes in the advance functions - the same thing happens - I can run them from the PC - but they wont work when run from the interface.
I have also rolled back to an earlier version - v3.238 and it now works
If a module that uses extended codes (ie LM12 wall dimmer) is programmed and added to a macro - when the macro runs - the light doesn't turn on.
I can see the codes in the Activity Monitor so the macro is running but the light does not respond.
If I turn the light on by using the GUI - the light comes on.
Also if I run the macro by clicking on it - it works. (I think this is because clicking on a macro runs the macro from the PC rather than the interface).
Changing the module to an old style one - it works ok.
I have also tried using the Extended codes in the advance functions - the same thing happens - I can run them from the PC - but they wont work when run from the interface.
I have also rolled back to an earlier version - v3.238 and it now works